Mitsubishi Grandis. Manual — part 6

GENERAL INFORMATION

SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR

54B-21

INTERIOR LAMP
INTERIOR LAMP DIMMER CONTROL
FUNCTION (THE INITIAL CONDITION: 15
SECONDS)

When the interior lamp switch is on the door position,
ETACS-ECU controls the interior lamp lamps as
follows.

1. When the ignition switch is OFF:

By opening any door or tailgate, the lamp turns ON

(100%), and dims (60%) when the door or
tailgate is closed, then and turns off after 15
seconds.

However, when the ignition switch is turned ON or

the driver’s door lock actuator switch is turned
ON, the lamps turn off at that time.

2. When the ignition switch is ON:

By opening any door or tailgate, the lamp (100%)

turns ON and OFF when the door or tailgate is
closed.

3. When all doors and the tailgate are closed, and

the ignition key is removed <Vehicles with
keyless entry system>:

By removing the ignition key with all doors and the

tailgate closed, the lamp turns ON 60%, and
turns off after 15 seconds.

By inserting the ignition key again or operating the

door lock with the lamp lit, the lamps turns off.

NOTE: For the vehicles with the keyless entry
system, the delayed interior lamp turning off duration
and the operation times of the keyless entry interior
lamp answer back can be changed by the customize
function.

AC310305

15 seconds

(All closed) OFF

(Any one open) ON

ON

OFF

Key removed

ACC

100 %

0 %

60 %

Door switch

(Unlock) OFF

(Lock) ON

Driver's door
lock actuator switch
(lock switch)

Interior lamp brightness

Ignition switch

15 seconds

AB

GENERAL INFORMATION

SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR

54B-22

Interior lamp automatic-shutoff function
<Vehicles with keyless entry system>
(the initial condition: with function)

When the interior lamp [all interior lamps connecting
to the room lamp fuse (the room lamp, the rear
personal lamps, the luggage compartment lamp, the
door lamp, the ignition key cylinder illumination
lamps and the door-ajar warning lamp)] is lit, but
either one of the following conditions is met, the
interior lamp is turned off automatically for preventing
the battery discharge caused by the unattended
operation or the door-ajar.

• After 30 minutes with the interior lamp lit while the

ignition switch is OFF, the lamp turns off
automatically.

• After 30 minutes with any door opened while the

ignition switch is OFF, the lamp turns off
automatically.

After automatic-shutoff function, the interior lamp
turns ON when any of the following condition is met.

• Open and close doors.

• Operate the keyless entry transmitter.

• Turn the ignition switch to ACC or ON.

NOTE: The interior lamp automatic-shutoff off time
can be customize by the customize function.

Ignition key cylinder illumination lamp
control function

The ETACS-ECU controls the ignition key cylinder
illumination lamp as described below.

1. The ignition key cylinder illumination lamp lights

for 30 seconds when the driver's door is
opened/closed with the ignition switch OFF.

2. When the ignition key is removed from the

ignition key cylinder, the ignition key cylinder
illumination lamp lights for 30 seconds (Vehicles
with keyless entry system).

3. When the ignition key cylinder illumination lamp

is operating with the doors closed, it goes out if
the ignition switch is turned ON.

AC212552AB

ON

OFF

ACC

Ignition switch

(All closed) OFF

(Any one open) ON

Door switch

(Illuminated) ON

(Extinguished) OFF

Interior lamp

t: Within 30 minutes

T: 30 minutes

T

T

t

t

t

AC309709

t : 30 seconds

(Closed) OFF

(Opened) ON

ON

OFF

(Key removed) ON

(Key inserted) OFF

(Illuminated) ON

(Extinguished) OFF

Driver's seat door switch

Key reminder switch

Ignition key cylinder
illumination lamp

Ignition switch (IG)

<Vehicle with keyless
entry system>

AC

t

t

t

t

t

t

t

GENERAL INFORMATION

SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR

54B-23

DOOR AJAR INDICATOR

The ETACS-ECU outputs the open/close status of
each door to the combination meter through CAN
communication. The combination meter receives the
transmitted signal and turns ON and OFF the
door-ajar indicator. The door-ajar indicator flashes
when the door-ajar warning function is activated
while the door-ajar indicator is ON (For more
information about the door-ajar warning function,
refer to ).

SEAT BELT INDICATOR

AC309955

ON

OFF

ON (Unfastened)

OFF (Fastened)

ON (Illuminated)

OFF (Not illuminated)

Ignition switch (IG1)

Seatbelt switch
(Driver's side)

ON (Unfastened)

OFF (Fastened)

Seatbelt switch
(Passenger's side)

Seat belt indicator

8 km/h

0 km/h

Vehicle speed

60 seconds or more

3 km/h

ON

OFF

AB

b

b

b

b

b

c

c

a

b

d

d

d

d

d

e

12 cycles

1 cycle

12 cycles

12 cycles

12 cycles

Seatbelt indicator

Seat occupancy sensor

ON (Seat
occupied)

OFF (Seat not
occupied)

a: 10 seconds

c: 10 seconds

:flash

e: approximately 3 seconds

b: approximately 0.5 second

b: approximately 0.5 second

d: 1 second

12 cycles

12 cycles

GENERAL INFORMATION

SMART WIRING SYSTEM (SWS) NOT USING SWS MONITOR

54B-24

The ETACS-ECU outputs the seat belt buckle
engagement status to the combination meter through
CAN communication. The combination meter
receives the transmitted signal and turns ON and
OFF the seat belt indicator. The seat belt indicator
flashes when the seat belt warning function is
activated while the seat belt indicator is ON (For
more information about the seat belt warning
function, refer to ).