Mitsubishi Grandis. Manual — part 655
ALTERNATOR AND IGNITION SYSTEM
ENGINE OVERHAUL
11B-15
<<B>> CAMSHAFT POSITION SENSING
CYLINDER REMOVAL
1. Using special tool Fly wheel stopper (MD998781),
hold the drive plate.
2. Removal the camshaft position sensing cylinder.
INSTALLATION SERVICE POINT
>>A<< CAMSHAFT POSITION SENSING
CYLINDER INSTALLATION
1. Using special tool Fly wheel stopper (MD998781),
hold the drive plate.
2. Tighten the camshaft position sensing cylinder to
the specified torque.
Tightening torque: 22
± 4 N⋅m
>>B<< CAMSHAFT POSITION SENSOR
SUPPORT INSTALLATION
1. Remove completely the FIPG remaining on the
camshaft position sensor support and cylinder
head.
2. Apply a 3
± 1 mm diameter bead of FIPG to the
indicated surface of the camshaft position sensor
support.
AK202738
MD998781
AD
<M/T>
AK300135
MD998781
AG
<A/T>
AK202738
MD998781
AD
<M/T>
AK300135
MD998781
AG
<A/T>
AK300004AE
3 mm
ALTERNATOR AND IGNITION SYSTEM
ENGINE OVERHAUL
11B-16
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent
>>C<< SPARK PLUG INSTALLATION
Using special tool Spark plug wrench (MB991398),
tighten the spark plug to the specified torque.
Tightening torque: 25
± 5 N⋅m
AK300130
MB991398
AD
EXHAUST MANIFOLD
ENGINE OVERHAUL
11B-17
EXHAUST MANIFOLD
REMOVAL AND INSTALLATION
M1113004900510
REMOVAL SERVICE POINT
<<A>> OXYGEN SENSOR REMOVE
Using special tool Oxygen sensor wrench
(MD998770), removal the oxygen sensor.
AK305761AB
1
2
3
4
8
5
6
7
49 ± 5 N·m
44 ± 5 N·m
14 ± 1 N·m
35 ± 6 N·m
14 ± 1 N·m
44 ± 4 N·m
44 ± 4 N·m
24 ± 3 N·m
Removal steps
1. Engine hanger
<<A>> >>B<<
2. Oxygen sensor
<<A>> >>B<<
3. Oxygen sensor
4. Exhaust manifold cover
5. Exhaust manifold bracket B
6. Exhaust manifold
7. Exhaust manifold gasket
8. Exhaust manifold bracket A
AK300132AD
MD998770
EXHAUST MANIFOLD
ENGINE OVERHAUL
11B-18
INSTALLATION SERVICE POINT
>>A<< EXHAUST MANIFOLD BRACKET
"B" INSTALLATION
Check to ensure that the exhaust manifold bracket
"B" is in close contact with the exhaust manifold and
the cylinder block before tightening the respective
mounting bolts to the specified torque.
>>B<< OXYGEN SENSOR INSTALLATION
Using special tool Oxygen sensor wrench
(MD998770), installation the oxygen sensor.
AK300131
AK300132AD
MD998770
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст