Mitsubishi Lancer Evolution VI. Manual — part 45
MPI –
On-vehicle Service
13-68
ON-VEHICLE SERVICE
FUEL PUMP RESISTOR CHECK
<EVOLUTION-VI>
Standard value: 0.45 – 0.65
Ω
The inspection procedures are the same as for the preceding
year-models.
FUEL PUMP RELAY No.2 CONTINUITY CHECK
<EVOLUTION-VI>
Battery voltage
Terminal No.
1
2
3
4
Not supplied
Supplied
ENGINE CONTROL RELAY AND FUEL PUMP
RELAY CONTINUITY CHECK
Battery voltage
Terminal No.
1
2
3
4
Not supplied
Supplied
Equipment side connector for engine
control relay and fuel pump relay
Fuel pump relay
Engine control relay
FUEL SUPPLY –
General / Fuel Tank
13-69
FUEL SUPPLY
GENERAL
OUTLINE OF CHANGE
The service procedures have been revised as shown below because of change in the fuel pump & gauge
assembly and the fuel gauge unit. <EVOLUTION-VI>
FUEL TANK <EVOLUTION-VI>
REMOVAL AND INSTALLATION
4
3
2
1
6
5
7
1
1
Removal steps
1. Fuel hose
2. Fuel pump & gauge assembly
3. Packing
"
A
A
4. High-pressure fuel hose
5. Fuel pipe assembly
6. Fuel gauge unit
7. Packing
NOTE
The service procedures other than those mentioned above
remain unchanged.
INSTALLATION SERVICE POINT
"
A
A
HIGH-PRESSURE FUEL HOSE INSTALLATION
Caution
After connecting the quick-release joint of the
high-pressure fuel hose, pull it gently in the direction
of removal to check that the hose is firmly connected
with a play of about 3 mm.
NOTES
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст