Mitsubishi Lancer Evolution VI. Manual — part 111
CHASSIS ELECTRICAL –
Speaker / Antenna
54-48
<REAR SPEAKER>
7
6
Rear shelf speaker removal steps
6. Speaker garnish
7. Speaker
ANTENNA
POLE ANTENNA
REMOVAL AND INSTALLATION
1
2
3
5
4
7
6
8
9
Removal steps
1. Pole
2. Radio panel
3. Radio and tape player
4. Hood lock release handle
5. Driver side lower cover
6. Clip
7. Cowl side trim
A
A
"
8. Antenna assembly
9. Antenna base gasket
CHASSIS ELECTRICAL –
Antenna
54-49
REMOVAL SERVICE POINT
A
A
"
ANTENNA ASSEMBLY REMOVAL
To facilitate the installation work of the antenna assembly,
perform the following before removing the feeder cable:
1.
Tie a cord to the end of the feeder cable.
2.
Pull out the antenna assembly until the end of the drain
pipe can be seen.
3.
Pass the cord through the hole in the end of the drain
pipe and wrap it with vinyl tape.
Caution
Wrap it securely so that the cord will not come off.
4.
Pull out the antenna assembly little by little to remove
it.
REAR WINDOW ANTENNA AND GLASS DIVERSITY ANTENNA
REMOVAL AND INSTALLATION
1
2
Removal steps
D
Glove box
D
Front pillar trim (LH), center pillar trim
(LH), rear pillar trim (LH)
D
Assist grip
1. Radio and tape player
A
A
"
2. Antenna assembly
Feeder cable
Cord
Cord
Tape
Hole
CHASSIS ELECTRICAL –
Antenna / Rear Window Defogger
54-50
REMOVAL SERVICE POINT
A
A
"
ANTENNA AMPLIFIER ASSEMBLY REMOVAL
Take off the left-hand edge of the hand lining and undo the
clips of the antenna amplifier assembly.
REAR WINDOW DEFOGGER
TROUBLESHOOTING <VEHICLES
WITH AUTOMATIC A/C>
Refer to GROUP 55.
ON-VEHICLE SERVICE
PRINTED-HEATER CHECK
1.
Run engine at 2,000 r/min. Check heater element with
battery at full.
2.
Turn ON rear window defogger switch. Measure heater
element voltage with circuit tester at rear window glass
centre A.
Condition is good if it indicates about 6V.
3.
If 12 V is indicated at A, there is a break in the negative
terminals from A.
Move test bar slowly to negative terminal to detect where
voltage changes suddenly (0V).
4.
If 0 V is indicated at A, there is a break in the positive
terminals from A. Defect where the voltage changes
suddenly (12 V) in the same method described above.
DEFOGGER RELAY CONTINUITY CHECK
Battery voltage
Terminal No.
Battery voltage
1
3
2
5
Power is not supplied
Power is supplied
Normal characteristic curve
Voltage
A (Centre point)
approx. 6 V
Positive
terminal
Printed heater line
Negative
terminal
Abnormal characteristic curve
Voltage
Open-circuit
point
Positive
terminal
Printed heater line
Negative
terminal
Junction block
Defogger relay
CHASSIS ELECTRICAL –
Rear Window Defogger
ILL
IND
ILL
54-51
REAR WINDOW DEFOGGER SWITCH
<VEHICLES WITH AUTOMATIC A/C>
REMOVAL AND INSTALLATION
Refer to GROUP – Heater Control Assembly.
INSPECTION
DEFOGGER SWITCH CONTINUITY CHECK
Switch
iti
Terminal No.
position
1
2
–
3
4
–
6
OFF
ON
OFF
←→
ON
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст