Mitsubishi Outlander (2013+). Manual — part 530
SUNROOF ASSEMBLY
BODY
42A-140
Q: Is the diagnosis code set?
YES :
Replace the sunroof motor assembly.
NO :
The diagnosis is complete.
CODE NO. L0632: S/R Switch fall
CAUTION
Before replacing the ECU, ensure that the input
and output signal circuits are normal.
COMMENTS ON TROUBLE SYMPTOM
Current trouble
• If each switch (up, open, close/down) of the sun-
roof switch has been ON for 60 seconds,
ETACS-ECU sets the diagnosis code No. L0632.
PROBABLE CAUSES
• Malfunction of the sunroof motor assembly
• Malfunction of the sunroof switch
• Damaged wiring harness and connectors
DIAGNOSTIC PROCEDURE
STEP 1. Check of open circuit in UP, OPEN, CLOS
line between sunroof motor assembly connector
and sunroof switch connector.
Q: Is the check result normal?
YES :
Go to Step 2.
NO :
Repair the connector(s) or wiring harness.
STEP 2. Diagnosis code recheck
Replace the sunroof switch. Recheck if the diagnosis
code is set.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the LOCK (OFF)
position to the ON position.
(3) Check if the diagnosis code is set.
Q: Is the diagnosis code set?
YES :
Replace the sunroof motor assembly.
NO :
The diagnosis is complete.
CODE NO. L0634: S/R Sensor signal
CAUTION
Before replacing the ECU, ensure that the input
and output signal circuits are normal.
COMMENTS ON TROUBLE SYMPTOM
Current trouble
• If the signal from one of two lid position detection
sensors cannot be detected, ETACS-ECU sets
the diagnosis code No. L0634.
PROBABLE CAUSES
• Malfunction of the sunroof motor assembly
DIAGNOSTIC PROCEDURE
Diagnosis code recheck
Recheck if the diagnosis code is set.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the LOCK (OFF)
position to the ON position.
(3) Check if the diagnosis code is set.
Q: Is the diagnosis code set?
YES :
Replace the sunroof motor assembly.
NO :
The diagnosis is complete.
CODE NO. L0637: S/R Position
CAUTION
Before replacing the ECU, ensure that the input
and output signal circuits are normal.
COMMENTS ON TROUBLE SYMPTOM
Current trouble
• If the roof lid glass position is out of the specified
area, ETACS-ECU sets the diagnosis code No.
L0637.
SUNROOF ASSEMBLY
BODY
42A-141
PROBABLE CAUSES
• Malfunction of the sunroof motor assembly
DIAGNOSTIC PROCEDURE
STEP 1. Check the sunroof fully closed position
(1) Carry out the learning procedures of the sunroof
fully closed position. Refer to
.
(2) Recheck if the diagnosis code is set.
a. Erase the diagnosis code.
b. Turn the ignition switch from the LOCK (OFF)
position to the ON position.
c. Check if the diagnosis code is set.
Q: Is the check result normal?
YES :
The diagnosis is complete.
NO :
Go to Step 2.
STEP 2. Diagnosis code recheck
Recheck if the diagnosis code is set.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the LOCK (OFF)
position to the ON position.
(3) Check if the diagnosis code is set.
Q: Is the diagnosis code set?
YES :
Replace the sunroof motor assembly.
NO :
The diagnosis is complete.
CODE NO. L0640: S/R Over load
CAUTION
Before replacing the ECU, ensure that the input
and output signal circuits are normal.
COMMENTS ON TROUBLE SYMPTOM
Current trouble
• If the anti-trap function is activated consecutively
five times or more, ETACS-ECU sets the diagno-
sis code No. L0640.
PROBABLE CAUSES
• Malfunction of the sunroof motor assembly
DIAGNOSTIC PROCEDURE
STEP 1. Check the sunroof fully closed position
(1) Carry out the learning procedures of the sunroof
fully closed position. Refer to
.
(2) Recheck if the diagnosis code is set.
a. Erase the diagnosis code.
b. Turn the ignition switch from the LOCK (OFF)
position to the ON position.
c. Check if the diagnosis code is set.
Q: Is the check result normal?
YES :
The diagnosis is complete.
NO :
Go to Step 2.
STEP 2. Diagnosis code recheck
Recheck if the diagnosis code is set.
(1) Erase the diagnosis code.
(2) Turn the ignition switch from the LOCK (OFF)
position to the ON position.
(3) Check if the diagnosis code is set.
Q: Is the diagnosis code set?
YES :
Replace the sunroof motor assembly.
NO :
The diagnosis is complete.
DATA LIST REFERENCE TABLE
M1426002100025
LIN (SUN ROOF)
Item No. M.U.T.-III display
Check condition
Normal condition
6001
S/R Part number
−
5850A265
6002
S/R Serial number
−
−
6003
S/R SOFT Ver
−
−
6004
S/R Position
−
−
6005
S/R Position initialize state
Initialisation not completed
Not done
Initialisation completed
OK
6006
S/R Overload(Motor lock)
Overload due to a motor lock not detected OFF
Overload due to a motor lock detected
ON
SUNROOF ASSEMBLY
BODY
42A-142
6007
S/R Overload(Pulse
change)
Overload due to a pulse modulation not
detected
OFF
Overload due to a pulse modulation
detected
ON
6010
S/R Power supply voltage
Always
System voltage
6011
S/R Open switch
The open switch is not being operated
Not actuated
The open switch is being operated
Actuated
6012
S/R Close switch
The close switch is not being operated
Not actuated
The close switch is being operated
Actuated
6013
S/R Tilt up switch
The tilt-up switch is not being operated
Not actuated
The tilt-up switch is being operated
Actuated
6014
S/R Ignition switch
When the ignition switch is turned to the
LOCK or ACC position.
OFF
When the ignition switch is turned to the
ON or START position.
ON
6015
S/R Ignition switch(LIN)
When the ignition switch is turned to the
LOCK or ACC position.
OFF
When the ignition switch is turned to the
ON or START position.
ON
6018
S/R Operation
Communication is not normal
Disable
Communication is normal
Enable
6019
S/R Multi close
The multi-close function not in progress
OFF
The multi-close function in progress
ON
6020
S/R Operation mode
−
Type 2
6021
S/R Vehicle speed
Perform a test run of the vehicle.
The values displayed
on the speedometer
and M.U.T.-III are
almost the same.
6022
S/R Position state
The sunroof position not confirmed
Undecided pos.
The sunroof is at tilt-up position.
Tilt up
The sunroof is slid to open.
Slide open
The sunroof is fully closed.
Full close
6023
S/R Sleep condition
Communication sleep conditions not
satisfied
OFF
Communication sleep conditions satisfied
ON
6024
S/R Motor
The motor not running
Not actuated
The motor running
Actuated
6026
S/R Log1(Trigger) Open
The open switch was not operated the last
time.
OFF
The open switch was operated the last
time.
ON
Item No. M.U.T.-III display
Check condition
Normal condition
SUNROOF ASSEMBLY
BODY
42A-143
6027
S/R Log1(Trigger) Close
The close switch was not operated the last
time.
OFF
The close switch was operated the last
time.
ON
6028
S/R Log1(Trigger) Tilt Up
The close switch was not operated the last
time.
OFF
The close switch was operated the last
time.
ON
6029
S/R Log1(Trigger) Multi
Close
The multi-close function was not operated
the last time.
OFF
The multi-close function was operated the
last time.
ON
6030
S/R Log1(Trigger) Overload Overload was not detected the last time.
OFF
Overload was detected the last time.
ON
6031
S/R Log1 IG-SW
The ignition switch was turned OFF the
last time.
OFF
The ignition switch was turned ON the last
time.
ON
6032
S/R Log1 Motor actuate
The motor did not operate the last time.
OFF
The motor operated the last time.
ON
6033
S/R Log1 Operation
Sunroof operation permission status was
"not permitted" the last time.
OFF
Sunroof operation permission status was
"permitted" the last time.
ON
6034
S/R Log2(Trigger) Open
The open switch was not operated the last
time but one.
OFF
The open switch was operated the last
time but one.
ON
6035
S/R Log2(Trigger) Close
The close switch was not operated the last
time but one.
OFF
The close switch was operated the last
time but one.
ON
6036
S/R Log2(Trigger) Tilt Up
The close switch was not operated the last
time but one.
OFF
The close switch was operated the last
time but one.
ON
6037
S/R Log2(Trigger) Multi
Close
The multi-close function was not operated
the last time but one.
OFF
The multi-close function was operated the
last time but one.
ON
6038
S/R Log2(Trigger) Overload Overload was not detected the last time
but one.
OFF
Overload was detected the last time but
one.
ON
Item No. M.U.T.-III display
Check condition
Normal condition
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст