Mitsubishi Montero (2002-2004). Manual — part 291
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-211
General circuit diagram regarding the sunroof
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-212
INSPECTION PROCEDURE F-1: Sunroof: Sunroof does not operate.
Sunroof Motor Assembly Power Supply Circuit
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-213
.
CIRCUIT OPERATION
• The sunroof motor assembly is energized
through fusible link (1) and (4).
• When the ignition switch (IG2) signal is on, the
sunroof motor assembly is ready to operate.
.
TROUBLESHOOTING HINTS
• The sunroof switch may be defective
• The sunroof motor assembly may be defective
• The wiring harness or connectors may have
loose, corroded or damaged terminals, or termi-
nals pushed back in the connector
ACX02274
FUSIBLE LINK (1), (4)
FUSIBLE LINK (1)
AH
BATTERY
FUSIBLE LINK (4)
AC000758
CONNECTORS: D-03, D-04, D-28, D-30, D-125
AV
D-125
D-28
D-30
D-04
D-03
ACX02285
CONNECTORS: D-207, D-208, D-210, D-221
AB
D-208
D-207
D-210
D-221
JUNCTION BLOCK (FRONT VIEW)
AC204484
AG
CONNECTORS: F-01, F-02, F-24
F-02
F-01(B)
F-24
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-214
DIAGNOSIS
Required Special Tool:
• MB991223: Harness Set
STEP 1. Check the fusible link (4) line of power supply
circuit to the sunroof motor assembly. Test at sunroof
motor assembly connector F-02.
(1) Disconnect sunroof motor assembly connector F-02 and
measure the voltage available at the wiring harness side of
the connector.
(2) Measure the voltage between terminal 1 and ground.
• The voltage should be approximately 12 volts (battery
positive voltage).
Q: Is the measured voltage approximately 12 volts (battery
positive voltage)?
YES : Go to Step 4.
NO : Go to Step 2.
STEP 2. Check the sunroof motor assembly connector F-
02 for loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Is sunroof motor assembly connector F-02 in good
condition?
YES : Go to Step 3.
NO : Repair or replace the damaged component(s). Refer
to GROUP 00E, Harness Connector Inspection
. The sunroof should now work normally.
AC203849AD
CONNECTOR: F-02
F-02
10
1
2
3
4
5
6
7
8
9
(HARNESS SIDE)
F-02
10
1
2
3
4
5
6
7
8
9
AC106228
CONNECTOR F-02
(HARNESS SIDE)
AD
AC203849AE
CONNECTOR: F-02
F-02
5
4
3
2
1
10
9
8
7
6
F-02
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст