Mitsubishi Montero (2002-2004). Manual — part 260
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-87
NOTE: Also check intermediate connector D-25 and junction
block connector D-217 for loose, corroded, or damaged termi-
nals, or terminals pushed back in the connector. If intermediate
connector D-25 or junction block connector D-217 is damaged,
repair or replace the damaged component(s) as described in
GROUP 00E, Harness Connector Inspection
.
Q: Is the wiring harness from the ETACS-ECU connector D-
222 (terminal 4) to driver's door lock actuator connector
H-10 (terminal 6) in good condition?
YES : Go to Step 7.
NO : The wiring harness may be damaged or the
connector(s) may have loose, corroded or damaged
terminals, or terminals pushed back in the connector.
Repair or replace the damaged component(s). Verify
that the central door locking system should now works
normally.
AC203859 AC
CONNECTOR: D-25
D-25
D-25
AC204173
CONNECTOR : D-217
AG
HARNESS SIDE
8
1
11 10
3
4
12
9
2
13
14
6 5
15
7
D-217
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-88
STEP 7. Check the wiring harness from the ETACS-ECU
connector D-222 (terminal 19) to driver's door lock
actuator connector H-10 (terminal 4).
AC204174
CONNECTOR : D-222
AB
1
2
3
5
6
4
9 8
121110
13
15 14
16
17
7
19
20
18
JUNCTION BLOCK SIDE
D-222
AC203774AC
CONNECTOR: H-10
H-10 (B)
DRIVER'S DOOR
1 2 3
4 5 6
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-89
NOTE: Also check intermediate connector D-25 and junction
block connector D-209 for loose, corroded, or damaged termi-
nals, or terminals pushed back in the connector. If intermediate
connector D-25 or junction block connector D-209 is damaged,
repair or replace the damaged component(s) as described in
GROUP 00E, Harness Connector Inspection
.
Q: Is the wiring harness from the ETACS-ECU connector D-
222 (terminal 19) to driver's door lock actuator
connector H-10 (terminal 4) in good condition?
YES : Replace the ETACS-ECU. Verify that the central door
locking system should now works normally.
NO : The wiring harness may be damaged or the
connector(s) may have loose, corroded or damaged
terminals, or terminals pushed back in the connector.
Repair or replace the damaged component(s). Verify
that the central door locking system should now works
normally.
AC203859 AC
CONNECTOR: D-25
D-25
D-25
AC204173
CONNECTOR : D-209
AD
HARNESS SIDE
1
2
6
7
9
3
4
11
12
10
5
13
8
D-209
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-90
INSPECTION PROCEDURE C-2: Central Door Locking System: Some doors do not lock or unlock.
Central Door Lock Circuit
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст