Mitsubishi Montero (2002-2004). Manual — part 272
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-135
General circuit diagram for the power windows
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-136
INSPECTION PROCEDURE D-1: Power Window: Power windows do not work at all.
NOTE: This troubleshooting procedure requires the use of scan tool MB991502 and SWS monitor kit
MB991862. For details on how to use the SWS monitor, refer to "How to use SWS monitor
."
Power Window Relay Circuit
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-137
.
CIRCUIT OPERATION
The ETACS-ECU turns on the power window relay to
activate the power windows when the ignition switch
(IG1) is in the "ON" position. The power window relay
is located in the under-dash junction block, to the left
of the steering column. It plugs into connector D-219.
.
TROUBLESHOOTING HINTS
• The power window relay may be defective
• The ETACS-ECU may be defective
• The wiring harness or connectors may have
loose, corroded or damaged terminals, or termi-
nals pushed back in the connector
ACX02274
FUSIBLE LINK (4)
AD
BATTERY
AC000758
CONNECTORS: D-25, D-28
AK
D-25
D-28
ACX02285
CONNECTORS: D-208, D-219, D-221
AG
D-208
D-219
JUNCTION BLOCK (FRONT VIEW)
D-221
POWER WINDOW
RELAY
AC203774
CONNECTOR: H-05
AD
DRIVER'S DOOR
H-05
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-138
DIAGNOSIS
Required Special Tools:
• MB991223: Harness Set
• MB991502: Scan Tool (MUT-II)
• MB991862: SWS Monitor Kit
STEP 1. Use scan tool MB991502 to select "ECU COMM
CHK" on the SWS monitor display.
Check the ETACS-ECU.
CAUTION
To prevent damage to scan tool MB991502, always turn the
ignition switch to the "LOCK" (OFF) position before con-
necting or disconnecting scan tool MB991502.
(1) Connect scan tool MB991502 to the data link connector
(16-pin).
(2) Connect SWS monitor kit MB991862 to the data link
connector (13-pin).
(3) Turn the ignition switch to the "ON" position.
(4) Operate scan tool MB991502 according to the procedure
below to display "ECU COMM CHK."
1. Select "SYSTEM SELECT."
2. Select "SWS."
3. Select "SWS MONITOR."
4. Select "ECU COMM CHK."
(5) Scan tool MB991502 should show "OK" on the "ECU
COMM ECU" menu for the ETACS ECU menu.
Q: Is "OK" displayed on the "ETACS ECU" menu?
"OK" is displayed for all the items : Go to Step 2.
"NG" is displayed on the "ETACS ECU" menu : Refer to
Inspection Procedure A-3 "Communication with
ETACS-ECU is not possible
."
AC204222AB
16-pin
13-pin
MB991502
MB991862
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст