Mitsubishi Montero (2002-2004). Manual — part 797
SRS AIR BAG DIAGNOSIS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DIAGNOSIS
52Bb-57
STEP 7. Check the harness for short circuit to ground
between junction block connector D-210 (terminal No.1)
and combination meter connector D-03 (terminal No.62).
Q: Are harness wires between junction block connector D-
210 (terminal No.1) and combination meter connector D-
03 (terminal No.62) in good condition?
YES : Go to Step 10.
NO : Repair the harness wires between junction block
connector D-210 and combination meter connector D-
03. Then go to Step 10.
ACX01632
CONNECTOR: D-210
JUNCTION BLOCK
(FRONT VIEW)
AH
D-210
AC204231 AC
D-03 (GR)
CONNECTOR : D-03
D-03 HARNESS CONNECOR:
COMPONENNT SIDE
60
51
65
59
63 62 61
64
54
52
53
55
56
67 66
57
58
SRS AIR BAG DIAGNOSIS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DIAGNOSIS
52Bb-58
STEP 8. Check the harness for short circuit to ground
between the SRS-ECU and the junction block.
(1) Disconnect SRS-ECU connector E-08, and measure at the
wiring harness.
CAUTION
Do not insert a test probe into the terminal from its front
side directly as the connector contact pressure may be
weakened.
(2) Check for continuity between E-08 harness connector
terminal 16 and body ground.
It should be open circuit.
Q: Is the circuit normal?
YES : Erase the diagnostic trouble code memory, and check
the diagnostic trouble code. If DTC 41 sets, replace
the SRS-ECU. (Refer to
.) Then go to Step
10.
NO : Go to Step 9.
ACX01478 AG
CONNECTOR: E-08
E-08 (Y)
AC204769
13 14 15 16 17 18 19 20
5 6 7 8 9 10 11 12
1 2
3 4
AB
E-08 HARNESS CONNECTOR:
HARNESS SIDE
SRS AIR BAG DIAGNOSIS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DIAGNOSIS
52Bb-59
STEP 9. Check the harness for short circuit ground
between SRS-ECU connector E-08 (terminal No.16) and
junction block connector D-210 (terminal No.2).
Q: Are harness wires between SRS-ECU connector E-08
(terminal No.16) and junction block connector D-210
(terminal No.2) in good condition?
YES : Go to Step 10.
NO : Repair the harness wire between SRS-ECU
connector E-08 and junction block connector D-210.
Then go to Step 10.
STEP 10. Recheck for diagnostic trouble code.
Q: Is DTC 41 set?
YES : Return to Step 1.
NO : The procedure is complete. (If no malfunctions are not
found in all steps, an intermittent malfunction is
suspected. Refer to GROUP 00, How to Use
Troubleshooting/Inspection Service Points
− How to
Cope with Intermittent Malfunction
ACX01478AH
CONNECTOR: E-08
E-08 (Y)
HARNESS
CONNECTOR:
HARNESS SIDE
AC204257
CONNECTOR : D-210
AD
D-210
D-210 HARNESS CONNECTOR:
COMPONENT SIDE
JUNCTION BLOCK
(FRONT VIEW)
5 4
3 2
12
13
10
11
7
8
1
6
9
SRS AIR BAG DIAGNOSIS
TSB Revision
SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DIAGNOSIS
52Bb-60
DTC 42: IG1 Power Circuit System (Fuse No.8 Circuit)
.
CIRCUIT OPERATION
• The SRS-ECU is powered from the ignition
switch (IG1).
• The SRS-ECU power is supplied from two cir-
cuits. Even if one circuit is shut off, the air bag
can inflate.
.
ACX01631
IG1 Power Circuit System (Fuse No.8 Circuit)
AC
ACX01632
CONNECTORS: D-208, D-210
D-208
D-210
JUNCTION BLOCK
(FRONT VIEW)
AG
ACX01478 AG
CONNECTOR: E-08
E-08 (Y)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст