Mitsubishi Montero (2002-2004). Manual — part 529
TRANSMISSION
TSB Revision
AUTOMATIC TRANSMISSION OVERHAUL
23B-47
CAUTION
Make sure thrust bearing number 12 is mounted in the cor-
rect direction.
18.Install the underdrive clutch. <V4A51>
19.Apply Vaseline or petroleum jelly on the thrust bearing
number 11, and then install on the front end of the
underdrive clutch retainer. <V4A51>
AKX00063
THRUST BEARING NO.12
OUTPUT
SHAFT
<V4A51>
AB
AKX00063
THRUST BEARING NO.12
DIRECT
PLANETARY
CARRIER
<V5A51>
AC
AKX00065
<V4A51>
AB
AKX00067
<V4A51>
AB
TRANSMISSION
TSB Revision
AUTOMATIC TRANSMISSION OVERHAUL
23B-48
CAUTION
Make sure thrust bearing number 11 is mounted in the cor-
rect direction.
20.Install the underdrive clutch hub. <V4A51>
21.Apply Vaseline or petroleum jelly on the thrust bearing
number 10, and then install it on the underdrive clutch hub.
<V4A51>
AKX00066
THRUST
BEARING NO.11
UNDERDRIVE
CLUTCH
RETAINER
<V4A51>
AB
AKX00068
<V4A51>
AB
AKX00070
<V4A51>
AB
TRANSMISSION
TSB Revision
AUTOMATIC TRANSMISSION OVERHAUL
23B-49
CAUTION
Make sure thrust bearing number 10 is mounted in the cor-
rect direction.
22.Install the output flange. <V4A51>
CAUTION
Confirm that the thrust bearing number 10 in the direct
annulus gear is still at specified location.
23.Insert the direct annulus gear. <V5A51>
24.Apply Vaseline or petroleum jelly on the thrust bearing
number 9, and then install on the output flange <V4A51> or
direct annulus gear <V5A51>.
AKX00069
THRUST
BEARING NO.10
UNDERDRIVE
CLUTCH HUB
<V4A51>
AB
AKX00071
<V4A51>
AB
AKX00302
<V5A51>
AB
AKX00073
TRANSMISSION
TSB Revision
AUTOMATIC TRANSMISSION OVERHAUL
23B-50
CAUTION
Make sure thrust bearing number 9 is mounted in the cor-
rect direction.
CAUTION
Measure and record the thickness of the thrust race num-
ber 8 to be assembled.
25.Apply Vaseline or blue petroleum jelly on the thrust race
number 8 being used, and then install it on the rear side of
the center support.
CAUTION
• Install the center support so that the oil holes shown in
the illustration face the lower side of the transmission
case.
• Make sure that the thrust race number 8 attached to the
rear side of the center support does not fall off.
26.Install the center support.
AKX00072
THRUST
BEARING NO.9
OUTPUT FLANGE
<V4A51>
AB
AKX00072
THRUST
BEARING NO.9
DIRECT
ANNULUS GEAR
<V5A51>
AC
AKX00074
THRUST RACE NO.8
AB
AKX00075
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст