Mitsubishi Montero (2002-2004). Manual — part 310
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-287
STEP 8. Check the wiring harness between rear washer
motor connector I-08 (terminal 2) and ETACS-ECU
connector D-222 (terminal 3).
ACX02293 AT
CONNECTOR: I-08
I-08 (B)
2
1
(HARNESS SIDE)
I-08 (B)
AC203853
CONNECTOR: D-222
AC
JUNCTION BLOCK (REAR VIEW)
D-222
(HARNESS SIDE)
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-288
NOTE: Also check intermediate connectors D-111,G-10 and
junction block connector D-221 for loose, corroded, or dam-
aged terminals, or terminals pushed back in the connector. If
intermediate connectors D-111,G-10 and junction block con-
nector D-221 is damaged, repair or replace damaged compo-
nent(s) as described in GROUP 00E, Harness Connector
Inspection
.
Q: Is the wiring harness between rear washer motor
connector I-08 (terminal 2) and ETACS-ECU connector
D-222 (terminal 3) in good condition?
YES : Replace the ETACS-ECU. Verify that the rear washer
works normally.
NO : The wiring harness may be damaged or the connector
may have loose, corroded or damaged terminals, or
terminals pushed back in the connector. Repair the
wiring harness as necessary. Verify that the rear
washer works normally.
AC204524
CONNECTOR: G-10
AC
G-10
G-10
AC203860AC
D-111
CONNECTOR: D-111
D-111
ACX02285
CONNECTOR: D-221
BX
JUNCTION BLOCK (FRONT VIEW)
D-221
D-221
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-289
SEAT BELT WARNING LIGHT
GENERAL DESCRIPTION CONCERNING SEAT BELT WARNING LIGHT
M1549023900068
The ECU related to the seat belt warning light func-
tion is as follows.
Seat belt warning light function
The seat belt warning light lights up and makes seat belt buck-
ling easier when the ignition switch is ON and the driver's seat
belt switch is ON (seat belt is not fastened).
General circuit diagram for the seat belt warning light function
FUNCTION
CONTROL ECU
Seat belt warning light function
ETACS-ECU
AC106176
ON
OFF
ON
OFF
ON
OFF
Ignition
switch
(IG1)
Seat belt
switch
Seat belt
warning
light
(Fastened)
(Illminated)
(Unillminated)
(Unfastened)
AB
SYMPTOM PROCEDURES
TSB Revision
SWS SYMPTOM PROCEDURES
54Bb-290
INSPECTION PROCEDURE I-1: Seat Belt Warning Light: Seat belt warning light does not illuminate.
NOTE: This troubleshooting procedure requires the
use of scan tool MB991502 and SWS monitor kit
MB991862. For details on how to use the SWS mon-
itor, refer to "How to use SWS monitor
Seat Belt Warning Light Circuit
AC204170
CONNECTORS : D-03, D-04
BK
D-03(GR)
D-04(GR)
AC204173
CONNECTORS: D-208, D-210
D-208
D-210
AR
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст