Mitsubishi Pajero Pinin. Manual — part 296
![](/vehicles/winoney/gatous/faminuwi/drouelind.png)
EXTERIOR –
Marks
51-20
(7) GDI mark
121 mm
Back door end line
Window moulding end line
42 mm
(6) Three diamonds mark
Back door end line
Key cylinder
165 mm
56 mm
2.
INSTALLATION PROCEDURE
(1) Clean the mark installation surfaces on the body with
unleaded petrol.
(2) Peel off the backing paper from the reverse side of the
marks, and then attach the marks to the vehicle body
so that they fit properly into position.
Caution
When attaching the marks, the surrounding
temperature should be 20 – 38 C and the air should
be completely free from dust.
If the surrounding temperature is lower than 20 C,
the marks and the places on the body where the marks
are to be attached should be heated to 20 – 38 C.
When the marks are attached, care should be used
not to allow bubble to enter between tape and the
body.
![](/vehicles/winoney/gatous/faminuwi/xxpplp.png)
EXTERIOR – Outside
Door Mirror
51-21
OUTSIDE DOOR MIRROR
REMOVAL AND INSTALLATION
1
3
2
4
4
5
A
A
6
Section A – A
Clip
A
A
1
5
A
A
A
A
1
7
<Electric remote-con-
trolled door mirror>
<Manual-controlled
door mirror >
Door mirror removal steps
1. Delta inner cover
2. Clip
3. Boot
4. Mirror assembly
A
A
" "
A
A
5. Mirror
Electric remote-controlled mirror
switch removal steps
6. Power window and remote-
controlled mirror switch assembly
(Refer to GROUP 42 – Door trim
and water proof film.)
7. Electric remote-controlled mirror
switch
![](/vehicles/winoney/gatous/faminuwi/kant.png)
EXTERIOR – Outside
Door Mirror
51-22
REMOVAL SERVICE POINT
A
A
"
MIRROR REMOVAL
Using a hand, push the upper part of mirror to tilt it. Apply
a protection tape as shown in the illustration. Insert a flat-tipped
screwdriver between a notch behind the mirror and the pivot
plate, and then pry off the lower part of mirror from the pivot
plate.
INSTALLATION SERVICE POINT
"
A
A
MIRROR INSTALLATION
While holding the pivot plate with a flat-tipped screwdriver,
push the mirror to engage the clips at its lower part with the
pivot plate.
Section A – A
Flat-tipped
screwdriver
Mirror
Pivot plate
Protection
tape
Notches
A
A
A
A
Section A – A
Flat-tipped
screwdriver
Mirror
Pivot plate
A
A
A
A
![](/vehicles/winoney/gatous/faminuwi/pmo.png)
EXTERIOR – Outside
Door Mirror
EXTERIOR – Outside
Door Mirror
51-23
INSPECTION
ELECTRIC REMOTE-CONTROLLED MIRROR
OPERATION CHECK
Battery connection terminal
Direction of
ti
1
2
3
6
7
operation
UP
DOWN
LEFT
RIGHT
Vehicles with
heater mirror
ELECTRIC REMOTE-CONTROLLED MIRROR SWITCH
CONTINUITY CHECK
Switch
Switch
position
Terminal No.
position
Left mirror
Right mirror
1
6
9
10
11
1
2
3
6
9
Adjustment switch
UP
DOWN
RIGHT
LEFT
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст