Mitsubishi Galant. Manual — part 369
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-46
INSPECTION PROCEDURE 2: When the Brake Pedal is Depressed, Auto-cruise Control is not
Cancelled.
AC004594 AB
Stoplight Switch Circuit
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-47
CIRCUIT OPERATION
This is the stoplight switch input signal circuit.
The signal is sent to the stoplight switch from multi-
purpose fuse 3, and is then sent to the auto-cruise
control-ECU.
TECHNICAL DESCRIPTION (COMMENT)
The cause is probably a malfunction of the stoplight
switch circuit.
TROUBLESHOOTING HINTS
•
Malfunction of the stoplight switch.
•
Damaged harness or connector.
•
Malfunction of the auto-cruise control-ECU.
DIAGNOSIS
Required Special Tool:
•
MB991223: Harness Set
STEP 1. Check if the stoplight illuminates.
Q: Is the stoplight illuminated?
YES : Go to Step 9.
NO : Go to Step 2.
AC004581
CONNECTOR: C-03
AB
AC004580AB
CONNECTOR: C-66
CONNECTOR
BLOCK(LH)
AC004595AB
CONNECTOR: C-85
JUNCTION BLOCK(REAR VIEW)
AC004572AB
CONNECTOR: C-52
AC004593AB
CONNECTOR: C-77
JUNCTION BLOCK
(FRONT VIEW)
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-48
STEP 2. Check the 12-Volt supply circuit voltage at
stoplight switch connector C-03.
(1) Disconnect stoplight switch connector C-03 and measure at
the harness side.
(2) Measure the voltage between terminal 2 and ground.
Q: Is the voltage approximately battery positive voltage?
YES : Go to Step 6.
NO : Go to Step 3.
STEP 3. Check stoplight switch connector C-03.
Q: Is the connector damaged?
YES : Repair or replace connector.
Refer to GROUP 00E, Harness Connector Inspection
.
Then check that the malfunction is eliminated.
NO : Go to Step 4.
1
2
3
4
ACX01922AC
STOPLIGHT SWITCH
CONNECTOR: C-03
AC004581
CONNECTOR: C-03
AB
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-49
STEP 4. Check intermediate connector C-66 and junction
connector C-85 and C-77.
Q: Is any connectors damaged?
YES : Repair or replace connector.
Refer to GROUP 00E, Harness Connector Inspection
.
Then check that the malfunction is eliminated.
NO : Go to Step 5.
STEP 5. Check the harness wire between fusible link No.1
and stoplight switch connector C-03.
Q: Is any harness wire between fusible link No.1 and
stoplight switch connector C-03 damaged?
YES : Repair the harness wire and then check that the
malfunction is eliminated.
NO : Check that the malfunction is eliminated.
If the malfunction is eliminated, replace the auto-
cruise control-ECU. (Refer to
.)
Then check that the malfunction is eliminated.
AC004580AB
CONNECTOR: C-66
CONNECTOR
BLOCK(LH)
AC004593AB
CONNECTOR: C-77
JUNCTION BLOCK
(FRONT VIEW)
AC004595AB
CONNECTOR: C-85
JUNCTION BLOCK(REAR VIEW)
AC004581
CONNECTOR: C-03
AB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст