Mitsubishi Galant. Manual — part 655
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-15
STEP 5. Check the column switch ground circuit at the
column switch connector C-60.
(1)Disconnect the column switch connector C-60 and measure
at the harness side.
(2)Measure the resistance between terminal 4 and ground.
Q: Is the resistance less than 2 ohm?
YES : Go to Step 8.
NO : Go to Step 6.
STEP 6. Check column switch connector C-60 for damage.
Q: Is column switch connector C-60 in good condition?
YES : Go to Step 7.
NO : Repair or replace it. Refer to GROUP 00E, Harness
Connector Inspection
. Confirm the DTC 12
is not displayed.
AC003088 AB
CONNECTOR C-60
(HARNESS SIDE)
AC003078 AB
CONNECTOR: C-60
COLUMN SWITCH
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-16
STEP 7. Check the harness wires between column switch
connector C-60 and ground.
NOTE: After checking junction block connectors C-73 and C-
84, check the wires. If junction block connectors C-73 and C-84
are damaged, repair or replace them. Refer to GROUP 00E,
Harness Connector Inspection
Q: Are the harness wires between column switch
connector C-60 and ground in good condition?
YES : There is no action to be taken.
NO : Repair them. Confirm the DTC 12 is not displayed.
AC003078 AB
CONNECTOR: C-60
COLUMN SWITCH
AC003082AD
JUNCTION BLOCK
(FRONT VIEW)
CONNECTOR: C-73
AC003080 AB
JUNCTION BLOCK
(REAR VIEW)
CONNECTOR: C-84
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-17
STEP 8. Check the column switch connector C-60 and
ETACS-ECU connector C-82 for damage.
Q: Are column switch connector C-60 and ETACS-ECU
connector C-82 in good condition?
YES : Go to Step 9.
NO : Repair or replace them. Refer to GROUP 00E,
Harness Connector Inspection
. Confirm the
DTC 12 is not displayed.
STEP 9. Check the harness wires between column switch
connector C-60 and ETACS-ECU connector C-82.
Q: Are the harness wires between column switch
connector C-60 and ETACS-ECU connector C-82 in
good condition?
YES : Go to Step 10.
NO : Repair them. Confirm the DTC 12 is not displayed.
AC003078 AB
CONNECTOR: C-60
COLUMN SWITCH
AC003082AC
JUNCTION BLOCK
(FRONT VIEW)
CONNECTOR: C-82
AC003078 AB
CONNECTOR: C-60
COLUMN SWITCH
AC003080 AB
JUNCTION BLOCK
(REAR VIEW)
CONNECTOR: C-84
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-18
STEP 10. Replacement of ECU.
(1)Replace the column switch.
(2)Confirm the DTC 12 is not displayed.
Q: Does DTC 12 set?
YES : Replace the ETACS-ECU. Confirm the DTC 12 is not
displayed.
NO : There is no action to taken.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст