Mitsubishi Galant. Manual — part 690
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-155
STEP 11. Check the harness wires between fog light relay
connector A-06X and fog light connectors A-28 and A-31
and combination meter connector C-29.
NOTE: After checking intermediate connectors C-05 and C-66,
check the wires. If intermediate connectors C-05 and C-66 are
damaged, repair or replace them. Refer to GROUP 00E,
Harness Connector Inspection
Q: Are the harness wires between fog light relay connector
A-06X and fog light connectors A-28 and A-31 and
combination meter connector C-29 in good condition?
YES : Go to Step 12.
NO : Repair them. The fog lights should illuminate
normally.
AC003128 AL
CONNECTOR: A-06X
FOGLIGHT
RELAY
BATTERY
AC003129 AK
A-31
CONNECTORS: A-28, A-31
A-28
AC003089 AC
CONNECTOR: C-05
AC003079 AB
CONNECTOR
BLOCK (LH)
CONNECTOR: C-66
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-156
STEP 12. Replacement of ECU
(1)Replace the front-ECU.
(2)The fog lights should illuminate normally.
Q: Do the fog lights illuminate normally?
YES : There is no action to be taken.
NO : Replace the ETACS-ECU. The fog light should
illuminate normally.
Inspection Procedure K-2: Fog light: Fog lights do not go out when the headlights (low-beam) are
turned off while the fog lights are on.
TECHNICAL DESCRIPTION (COMMENT).
If the malfunction above occurs, the front-ECU may
be defective.
TROUBLESHOOTING HINT
Malfunction of the front-ECU
DIAGNOSIS
Replace the front-ECU.
The fog lights should go out when the headlights (low-beam)
are turned off while the fog lights are on.
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-157
Inspection Procedure L-1: Dome light: Dome light does not illuminate.
Dome Light Drive Circuit
AC004215
SWS DIAGNOSIS
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-158
CIRCUIT OPERATION
The dome light dimming function and the keyless
entry system answerback function illuminate the
dome light when the dome light switch is at "door
controlled operation position."
TECHNICAL DESCRIPTION (COMMENT)
If the dome light dose not illuminate at all, the dome
light bulb may be burned out, or the power supply
circuit or the ETACS-ECU may be defective.
TROUBLESHOOTING HINTS
•
Malfunction of the dome light
•
Malfunction of the ETACS-ECU
•
Damaged harness wires or connectors
DIAGNOSIS
Required Special Tools:
•
MB991223: Test Harness Set
STEP 1. Check the trouble symptom.
Q: Does the dome light illuminate when the dome light
switch is turned to "ON" position?
YES : Go to Step 2.
NO : Go to Step 3.
AC003079 AB
CONNECTOR
BLOCK (LH)
CONNECTOR: C-66
AC003082 AN
CONNECTORS: C-73, C-76
C-73
JUNCTION BLOCK
(FRONT VIEW)
C-76
AC003080AC
C-86
JUNCTION BLOCK
(REAR VIEW)
CONNECTORS: C-84, C-86
C-84
AC003176 AB
CONNECTOR: D-06
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст