Mitsubishi Galant 9G. Manual — part 466
EMISSION CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-82
<3.8L ENGINE>
COMPONENT LOCATION
M1173007400189
POSITIVE CRANKCASE VENTILATION SYSTEM
CHECK
M1173001100232
1. Remove the positive crankcase ventilation (PCV) valve from
the rocker cover, then reconnect the PCV valve to the
vacuum supply hose.
2. With the engine idling, put your finger on the open end of the
PCV valve, and check for negative pressure (vacuum).
NOTE: At this time, the plunger in the PCV valve should
move back and forth as the open end is covered and uncov-
ered.
3. If negative pressure is not felt, clean or replace the PCV
valve. Inspect the vacuum supply hose and vacuum supply
hose port for restriction or plugged condition.
AK303639
POSITIVE CRANKCASE
VENTILATION VALVE
VENTILATION HOSE
BREATHER HOSE
AB
AK301395AB
POSITIVE CRANKCASE VENTILATION VALVE
<2.4L ENGINE>
AK203691AC
POSITIVE CRANKCASE VENTILATION VALVE
<3.8L ENGINE>
AK203692
POSITIVE CRANKCASE
VENTILATION VALVE
AC
EMISSION CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-83
POSITIVE CRANKCASE VENTILATION VALVE
CHECK
M1173001200228
1. Hold the positive crankcase ventilation (PCV) valve with the
vacuum side down. Insert a thin rod, and using light
pressure, depress the end of the PCV valve spring by 5
− 10
mm (0.2
− 0.3 inch). Release pressure on the rod to see if
the PCV valve spring will lift the rod to its original position.
2. If the rod returns quickly to its original position, the PCV
valve is OK. If the stick does not return quickly, clean or
replace the PCV valve.
EVAPORATIVE EMISSION CONTROL SYSTEM
GENERAL DESCRIPTION (EVAPORATIVE EMISSION SYSTEM)
M1173005100706
The evaporative emission (EVAP) system prevents
fuel vapors generated in the fuel tank from escaping
into the atmosphere.
Fuel vapors from the fuel tank flow through the vapor
pipe/hose to be stored temporarily in the EVAP can-
ister.
When the vehicle is in operation, fuel vapors stored
in the EVAP canister flow through the EVAP purge
solenoid, purge port and intake manifold plenum to
the combustion chamber.
When the engine coolant temperature is low or when
the intake air quantity is small (when the engine is at
idle, for example), the powertrain control module
(PCM) brings the EVAP purge solenoid into the OFF
state to shut off the fuel vapor flow to the intake man-
ifold plenum. This ensures driveability when the
engine is cold or running under low load and also
stabilizes the emission level.
An EVAP ventilation solenoid is provided between
the EVAP canister and atmosphere to monitor for
OBD-II EVAP leaks. This solenoid is normally OFF.
However, it turns ON when monitoring the OBD-II
EVAP leaks and shuts off the atmosphere flow to the
EVAP canister. Then the fuel tank differential pres-
sure sensor monitors the fuel vapor pressure to
detect OBD-II EVAP leaks. The fuel overflow limiter
valve and the leveling valve prevent fuel from being
overfilled. The fuel overflow limiter valve and the lev-
eling valve prevents fuel leaks if the vehicle is rolled
over in an accident.
The EVAP ventilation valve releases the air from the
fuel tank through the EVAP canister into the atmo-
sphere when the fuel tank pressure increases due to
refueling, etc. The EVAP ventilation valve and the air
filter supply the atmospheric air to the EVAP canister
when the fuel tank pressure decreases.
AK301831
5 – 10 mm
(0.2 – 0.3 in)
THIN ROD
(VERY SMOOTH)
POSITIVE
CRANKCASE
VENTILATION
VALVE
VACUUM SIDE
AB
EMISSION CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-84
SYSTEM DIAGRAM
<2.4L ENGINE>
AK300555
FUEL TANK DIFFERENTIAL
PRESSURE SENSOR
LIQUID SEPARATOR
EVAPORATIVE
EMISSION
CANISTER
EVAPORATIVE
EMISSION
PURGE
SOLENOID
ON: OPEN
PCM
BAROMETRIC PRESSURE
SENSOR
INTAKE AIR TEMPERATURE
SENSOR
ENGINE COOLANT
TEMPERATURE SENSOR
MASS AIRFLOW SENSOR
FUEL
TANK
MFI RELAY
FUEL OVERFLOW
LIMITER VALVE
FUEL CUT
OFF VALVE
LEVELING VALVE
EVAPORATIVE EMISION
VENTILATION VALVE
AIR FILTER
EVAPORATIVE EMISSION
VENTILATION SOLENOID
ON: CLOSED
AB
EMISSION CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-85
<3.8L ENGINE>
COMPONENT LOCATION
M1173007500205
AK401681
FUEL TANK DIFFERENTIAL
PRESSURE SENSOR
EVAPORATIVE
EMISSION
CANISTER
LEVELING
VALVE
FUEL CUT
OFF VALVE
FUEL
OVERFLOW
LIMITER
VALVE
EVAPORATIVE
EMISSION
PURGE
SOLENOID
ON: OPEN
PCM
BAROMETRIC PRESSURE
SENSOR
INTAKE AIR TEMPERATURE
SENSOR
ENGINE COOLANT
TEMPERATURE SENSOR
MASS AIRFLOW SENSOR
FUEL
TANK
MFI
RELAY
FUEL
PUMP
EVAPORATIVE
EMISSION
VENTILATION VALVE
AIR FILTER
EVAPORATIVE
EMISSION
VENTILATION SOLENOID
ON: CLOSED
AB
LIQUID
SEPARATOR
FUEL PRESSURE
REGULATOR
AK303004AB
EVAPORATIVE EMISSION PURGE SOLENOID
<2.4L ENGINE>
INTAKE
MANIFOLD
AK303005AB
EVAPORATIVE EMISSION PURGE SOLENOID
<3.8L ENGINE>
AK303006 AB
EVAPORATIVE EMISSION VENTILATION
SOLENOID
EVAPORATIVE
EMISSION CANISTER
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст