Mitsubishi L200. Manual — part 313
AK503512
48 ± 6 N·m
39
40
41
43
44
45
46
48
47
49
50
23 ± 3 N·m
42
AE
51
Apply automatic
transmission fluid
to all moving parts
before installation.
39. Converter housing
40. Oil pump
41. Oil pump gasket
42. Thrust race No.1
43. Thrust bearing No.2
44. Reverse and overdrive clutch
45. Thrust bearing No.3
46. Overdrive clutch hub
47. Thrust bearing No.4
48. Reverse sun gear
49. Snap ring
50. Second brake
51. Return spring
TRANSMISSION
AUTOMATIC TRANSMISSION OVERHAUL <R4A5>
23B-16
AKX00019
52
53
54
55
56
57
58
59
60
62
61
AG
Apply automatic
transmission fluid
to all moving parts
before installation.
63
52. Pressure plate
53. Brake plate
54. Brake disc
55. Low/reverse annulus gear
56. Thrust bearing No.7
57. Snap ring
58. Reaction plate
59. Snap ring
60. Brake plate
61. Brake disc
62. Pressure plate
63. Wave spring
TRANSMISSION
AUTOMATIC TRANSMISSION OVERHAUL <R4A5>
23B-17
AK800433
Apply automatic
transmission fluid
to all moving parts
before installation.
64
65
66
67
68
69
70
71
72
73
75
74
78
77
76
79
81
80
23 ± 3 N·m
AB
64. Snap ring
65. Center support
66. Thrust race No.8
67. Thrust bearing No.9
68. Output flange
69. Thrust bearing No.10
70. Underdrive clutch hub
71. Thrust bearing No.11
72. Underdrive clutch
73. Thrust bearing No.12
74. Output shaft
75. Seal ring
76. Seal ring
77. Thrust bearing No.13
78. Bearing retainer
79. Output shaft support
80. Output shaft support gasket
81. Transmission case
TRANSMISSION
AUTOMATIC TRANSMISSION OVERHAUL <R4A5>
23B-18
TRANSMISSION
AUTOMATIC TRANSMISSION OVERHAUL <R4A5>
23B-19
DISASSEMBLY
CAUTION
• The automatic transmission includes many
high-precision parts. Handle these parts
extremely carefully not to scratch or damage
them during disassembly and reassembly.
• Work bench should be covered with a rubber
mat and keep it clean at all times.
• Do not wear any cloth gloves and do not use
any rags during disassembly. Use only nylon
cloth or paper towels if necessary.
• All removed parts must be washed clean.
Metal parts may be washed in an ordinary sol-
vent, but they should be dried completely
using compressed air.
• Clutch discs, plastic thrust plates and rubber
parts should be washed in automatic trans-
mission fluid (ATF) and keep them free of dirt
after washing.
•
AK603561
If the transmission has been found damaged
and repaired, also disassemble and clean the
ATF cooler system.
1. Remove the torque converter.
AK403341
2. Remove the input shaft speed sensor.
AK403342
3. Remove the output shaft speed sensor.
AK403343
Inhibitor switch
Manual control lever
AB
4. Remove the manual control lever, and then
remove the inhibitor switch.
AK800430AB
Snap ring
Parking gear
5. Remove the snap ring, and remove the parking
gear using a puller (corresponding load
approximately 9,800 N).
CAUTION
Carefully hammer the special tool so that the oil
pan mounting surface is not damaged.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст