Mitsubishi Lancer Evolution 7. Manual — part 343
BODY -
Doors
42-33
REMOVAL SERVICE POINTS
A
A" WINDOW REGULATOR ASSEMBLY/POWER
WINDOW MOTOR ASSEMBLY REMOVAL
1. Loosen the door window glass assembly mounting bolts.
2. Raise the door window glass assembly, and then adhere
the special tool on the glass as shown in the illustration
to prevent from falling.
CautionFor the door window glass adhered film and
etc., use the special tool from outside the door glass
to prevent unstucking.
3. Remove the power window regulator and motor assembly.
A
B" DOOR CENTER SASH REMOVAL
1. Remove only the section of the door outer opening
weatherstrip
2. Remove the center sash upper mounting screws, and
then remove the center sash upper from the door panel.
INSTALLATION SERVICE POINTS
"
AA WINDOW REGULATOR ASSEMBLY/POWER
WINDOW MOTOR ASSEMBLY INSTALLATION
When installing the window regulator assembly, tighten he
bolts at the specified torque in the order shown in the
illustration.
MB990480
Door outer opening
weatherstrip
Door center sash
A18X0127
<REAR DOOR>
<FRONT DOOR>
1
2
4
3
5
6
1
2
3
4
5
6
7
BODY -
Doors
BODY -
Doors
42-34
"
BA OPERATION CHECK <Vehicles with power
window>
1. Install the glass to the window regulator assembly.
Caution
(1) As fully open position which is programed in the
power window-ECU is released (initialized), the
window regulator assembly should not be
operated until it is installed to the glass.
(2) The clamping prevention function does not
operate the first time that the glass is fully closed.
2. Press the power window switch to fully-open the glass,
and then return the glass toward the fully-close position
about 30 mm each. In the fully-close position, keep on
pressing the power window switch for 0.5 second or more.
NOTE
This operation will program the power window-ECU.
INSPECTION
POWER WINDOW RELAY CONTINUITY CHECK
Battery voltage
Terminal No.
y
g
1
3
4
5
Not applied
Applied
Power window
relay
1 2 3
4
5
BODY -
Doors
42-35
DOOR HANDLE AND LATCH
REMOVAL AND INSTALLATION
Pre-removal Operation
Door Trim Removal (Refer to P.42-27.)
Post-installation Operation
D
Door Inside Handle Looseness Check (Refer to
P.42-24.)
D
Door Outside Handle Looseness Check (Refer to
P.42-23.)
D
Door Trim Installation (Refer to P.42-27.)
<FRONT DOOR>
<REAR DOOR>
3
5
4
7
2
6
1
5.9 ± 1.0 N·m
8.9 ± 1.9 N·m
2
1
7
5
6
2.5 ± 0.5 N·m
2.5 ± 0.5 N·m
Door handle and door latch
removal steps
"
CA 1. Door inside handle
D
Waterproof film (Refer to P.42-27.)
D
Door window glass lower runchan-
nel (Refer to P.42-38, 39.)
D
Door center sash (Refer to
P.42-32.)
2. Door outside handle
3. Key cylinder
"
BA 4. Lower sash
5. Door latch assembly
6. Link
Door check removal steps
D
Waterproof film (Refer to P.42-27.)
"
AA 7. Door check
INSTALLATION SERVICE POINTS
"
AA DOOR CHECK INSTALLATION
Install with the following identification marks upward.
Items
Identification mark
Front door
Left side
21L
Right side
21R
Rear door
Left side
36L
Right side
36R
Identification
mark
BODY -
Doors
BODY -
Doors
42-36
"
BA LOWER SASH INSTALLATION
Be sure to install the lower sash to the window rear sash
(at door) securely.
"
CA DOOR INSIDE HANDLE INSTALLATION
1. Install the inside lock cable to the door inside handle
as follows:
(1) Install the inner cable end in the inside lock cable
to the clip in the door inside handle.
(2) Turn the inside lock knob to the door lock position.
(3) Install the outer cable end to the door inside handle
securely.
(4) Install the clip to the inner cable.
2. Install the inside handle rod to the door inside handle.
3. Install the door inside handle to the door.
INSPECTION
DOOR LOCK ACTUATOR CHECK
Front door
<Left side (Driver’s side)>
Rod position
Terminal No.
Rod operation
1
2
3
4
6
LOCK
LOCK to UNLOCK
UNLOCK
UNLOCK to LOCK
LOCK
UNLOCK
<Left side (Passenger’s side)>
Rod position
Terminal No.
Rod operation
4
6
LOCK
LOCK to UNLOCK
UNLOCK
UNLOCK to LOCK
<Right side (Driver’s side)>
Rod position
Terminal No.
Rod operation
1
2
3
4
6
LOCK
LOCK to UNLOCK
UNLOCK
UNLOCK to LOCK
LOCK
UNLOCK
<Right side (Passenger’s side)>
Rod position
Terminal No.
Rod operation
p
4
6
p
LOCK
LOCK to UNLOCK
UNLOCK
UNLOCK to LOCK
Door inside
handle
Inner cable
Clip
Outer cable
end
Inside
handle rod
<Front door>
B
Unlock
<Left side>
View B
Lock
<Right side>
View A
Unlock
Lock
A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст