Mitsubishi Evolution X. Manual — part 856
AC102664 AB
DRIVESHAFT ASSEMBLY
TSB Revision
FRONT AXLE
26-25
11.Align the center groove on the EBJ boot big end with the
EBJ case groove.
12.Follow the same procedure as in step 5 to adjust the size of
the opening (W) on the special tool so that it is at the
standard value.
Standard value (W): 3.2 mm (0.13 inch)
AC102665 AB
D
E
Boot
Projection
Boot band
(large)
13.Position the EBJ boot band (large) so that there is even
clearance at either end (D and E).
14.Use special tool MB991561 to crimp the EBJ boot band
(large) in the same way as in step 7.
AC102666
F
AB
15.Check that the crimping amount (F) of the boot band is at
the standard value.
Standard value (F): 2.4
− 2.8 mm (0.10 − 0.11 inch)
If the crimping amount is larger than 2.8 mm (0.11
inch)
Readjust the value of (W) in step 12 according to
the following formula, and then repeat the opera-
tion in step 14.
W = 5.8 mm (0.23 inch)
− F
Example: If F = 2.9 mm (0.11 inch), then W = 2.9 mm
(0.11 inch)
If the crimping amount is smaller than 2.4 mm (0.10
inch)
Remove the EBJ boot band, readjust the value of
(W) in step 12 according to the following formula,
and then repeat the operations in steps 13 and 14
using a new EBJ boot band.
W = 5.8 mm (0.23 inch)
− F
Example: If F = 2.3 mm (0.09 inch), then W = 3.5 mm
(0.14 inch)
16.Check that the boot band is not sticking out past the place
where it has been installed. If the boot band is sticking out,
remove it and then repeat steps 13 to 15, using a new boot
band.
NOTES
33-1
GROUP 33
FRONT
SUSPENSION
CONTENTS
GENERAL INFORMATION . . . . . . . .
FASTENER TIGHTENING
SPECIFICATIONS . . . . . . . . . . . . . . .
GENERAL SPECIFICATIONS . . . . . .
SERVICE SPECIFICATIONS. . . . . . .
FRONT SUSPENSION DIAGNOSIS .
INTRODUCTION TO FRONT SUSPENSION
DIAGNOSIS . . . . . . . . . . . . . . . . . . . . . . . .
FRONT SUSPENSION DIAGNOSIS
TROUBLESHOOTING STRATEGY . . . . . .
SYMPTOM CHART. . . . . . . . . . . . . . . . . . .
SYMPTOM PROCEDURES . . . . . . . . . . . .
SPECIAL TOOLS. . . . . . . . . . . . . . . .
ON-VEHICLE SERVICE. . . . . . . . . . .
FRONT WHEEL ALIGNMENT CHECK AND
ADJUSTMENT . . . . . . . . . . . . . . . . . . . . . .
LOWER ARM BALL JOINT LOOSENESS
CHECK . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BALL JOINT DUST COVER CHECK . . . . .
STRUT ASSEMBLY . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . . . . . .
INSPECTION. . . . . . . . . . . . . . . . . . . . . . . .
DISASSEMBLY AND REASSEMBLY . . . . .
INSPECTION. . . . . . . . . . . . . . . . . . . . . . . .
LOWER ARM . . . . . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . . . . . .
LOWER ARM CHECK. . . . . . . . . . . . . . . . .
LOWER ARM BALL JOINT DUST COVER
REPLACEMENT . . . . . . . . . . . . . . . . . . . . .
STABILIZER BAR. . . . . . . . . . . . . . . .
REMOVAL AND INSTALLATION . . . . . . . .
STABILIZER LINK CHECK . . . . . . . . . . . . .
GENERAL INFORMATION
TSB Revision
FRONT SUSPENSION
33-2
GENERAL INFORMATION
M1332000101198
The MacPherson strut type suspension is adopted.
CONSTRUCTION DIAGRAM
AC703648 AC
Strut assembly
Stabilizer bar
Stabilizer link
Coil spring
Lower arm
Front axle crossmember
Crossmember brace
Lower brace bar
FASTENER TIGHTENING SPECIFICATIONS
M1332008500335
Item
Specification
Lower arm assembly
Lower arm to crossmember connection bolt (Front)
110
± 11 N⋅ m (81 ± 8 ft-lb)
Lower arm to crossmember connection nut (Rear)
110
± 11 N⋅ m (81 ± 8 ft-lb)
Lower arm to knuckle connection nut
71
± 10 N⋅ m (53 ± 7 ft-lb)
Lower arm to stabilizer link bracket connection bolt
39
± 5 N⋅ m (29 ± 4 ft-lb)
Stabilizer bar
Stabilizer fixture bolt
31
± 4 N⋅ m (23 ± 3 ft-lb)
Stabilizer link bracket to Lower arm connection bolt
39
± 5 N⋅ m (29 ± 4 ft-lb)
Stabilizer to stabilizer link connection nut
39
± 6 N⋅ m (29 ± 4 ft-lb)
Stabilizer bracket to stabilizer link connection nut
39
± 6 N⋅ m (29 ± 4 ft-lb)
Strut assembly
Strut assembly self-locking nut
61
± 9 N⋅ m (45 ± 7 ft-lb)
Strut assembly to body connection nut
45
± 7 N⋅ m (33 ± 5 ft-lb)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст