Mitsubishi Outlander XL. Manual — part 7

17. Rear door beltline inner reinforcement
18. Rear door window sash front
19. Rear door outer panel
20. Rear door window sash upper
21. Rear door window sash rear

22. Rear door beltline outer reinforcement
23. Rear door inner rear reinforcement
24. Rear door sash reinforcement
25. Rear door latch reinforcement
26. Rear door inner panel

SILENCER APPLICATION LOCATIONS

M40100000050USA0000010001

A silencer (MD-12) has been affixed on the upper
surface of the floor for vibration damping.

NOTE:

MD-12 is a high-performance sheet made of

asphalt, to which mica, heat cured resin, and so
on are added to improve damping performance.

ZB5004170000

: 1.6 mm thick melting sheet
: 3.6 mm thick MD-12 [Place three 1.6 mm melting sheet one on top of another.]

NOTE:

( ) indicates the number of melting sheets

that are used for repair.

BODY CONSTRUCTION

1-25

SILENCER APPLICATION LOCATIONS

LOCATIONS USING URETHANE FOAM AND FOAM MATERIAL

M40100000180USA0000010000

1.

Foam noise absorbing materials have been
adopted to the upper and lower sections of the
front pillar, center pillar lower section, rear pillar,
gate pillar, and wheel house arch inside to shield
from external noise.

2.

Urethane foam has been inserted into the quarter
inner lower section to shield from external noise.

The foam materials may burn when heated.
Always observe the following instructions:

｠

Never use a gas burner to burn the areas where
foam materials are used.

｠

When cutting the parts which are provided with
foam materials, ensure to use tools (air saw,
etc.) that do not generate fire.

｠

If there are residual foam materials remaining
on the cut section (body side), remove the foam
materials from periphery of the welding area
before welding work.

ZB6010200000

1

1

1

2

STIFFENER AND DAMP SHEET APPLICATION LOCATIONS

M40100000181USA0000010000

Spray-type stiffeners on the inner side of the side
outer panel, sheet-type stiffeners on the inner side of
the liftgate outer panel, and a damp sheet on the

1-26

BODY CONSTRUCTION

LOCATIONS USING URETHANE FOAM AND FOAM MATERIAL

interior side of the front deck have been used for
higher surface rigidity.

NOTE:

｠

The spray-type stiffener is mainly made from epoxy
resin and contains filler. The sheet-type one is
additionally reinforced with glass fiber. The stiffener

is cured by heating in the paint drying furnace during
the production.

｠

No spare part of the stiffener for repair is available
in the field. If the stiffener is damaged, replace it
together with the panel.

｠

The spare part for the panel provided with the
stiffener has a sheet-type stiffener affixed.

ZB5004220000

Stiffener

Stiffener

ZB500421

Stiffener

0000

Damp sheet

Liftgate

Front deck

BODY CONSTRUCTION

1-27

STIFFENER AND DAMP SHEET APPLICATION LOCATIONS

MEMO

1-28

BODY CONSTRUCTION