Mitsubishi Outlander XL. Manual — part 1044
Item No.
Scan tool MB991958 display
Condition
235
Front wiper ACT
ON or OFF
236
Front wiper Lo/Hi
ON or OFF
237
Front washer
ON or OFF
238
Rear washer
ON or OFF
239
Rear wiper
ON or OFF
240
Power window
ON or OFF
241
Hold mirror open
ON or OFF
242
Hold mirror close
ON or OFF
243
Dead lock
ON or OFF
244
Independent DRL
ON or OFF
251
Auto Light Sensor
Voltage
252
Ambient Temperature Sensor
Voltage
253
Voltage sensing of IOD Line
Voltage
254
IG voltage
Voltage
255
Theft sensor
ON or OFF
256
Dr door ajar switch
Open or Close
257
As door ajar switch
Open or Close
258
RR door ajar switch
Open or Close
259
RL door ajar switch
Open or Close
260
Trunk/gate trunk ajar switch
Open or Close
262
Room lamp center ON switch
ON or OFF
263
Room lamp center OFF switch
ON or OFF
264
Handle lock switch
Key out or Key in
265
Hazard switch
ON or OFF
266
Hood switch
ON or OFF
267
Mirror switch
ON or OFF
268
Trunk/gate opener switch
ON or OFF
270
Dr door lock switch
Unlock or Not Unlock
271
Dr door unlock switch
Unlock or Not Unlock
272
As door unlock switch
Unlock or Not Unlock
273
Except Dr/As door unlock switch
Unlock or Not Unlock
274
Door key lock switch
ON or OFF
275
Dr door key unlock switch
ON or OFF
276
Door key unlock switch
ON or OFF
277
Power lock switch
ON or OFF
278
Power unlock switch
ON or OFF
279
Brake fluid switch
ON or OFF
280
Washer fluid switch
ON or OFF
281
ASC/TCL OFF switch
ON or OFF
ETACS
54Ad-55
DIAGNOSIS
Item No.
Scan tool MB991958 display
Condition
287
Starter switch
ON or OFF
288
ACC switch
ON or OFF
289
Backup lamp or shift reveres SW
ON or OFF
290
Brake switch
ON or OFF
291
Front wiper auto stop switch
ON or OFF
292
Rear wiper auto stop switch
ON or OFF
293
Process error information
-
294
Process error
times
295
Rear sunroof unlock
ON or OFF
340
Head light switch(tail)
ON or OFF
341
Head light switch
ON or OFF
342
Head light switch(Dimmer)
ON or OFF
343
Turn switch left
ON or OFF
344
Turn switch right
ON or OFF
345
Fog light ON
ON or OFF
346
Fog light OFF
ON or OFF
347
Switch type
LHD or RHD
348
Head light switch(auto)
ON or OFF
349
Head light cleaner
ON or OFF
350
Head light switch(flasher)
ON or OFF
351
Column ECU sleep
OK or NG
352
Front wiper(INT)
ON or OFF
353
Front wiper(LO)
ON or OFF
354
Front wiper(HI)
ON or OFF
355
Front wiper(washer)
ON or OFF
356
Rear wiper
ON or OFF
357
Rear wiper(washer)
ON or OFF
358
Front wiper(MIST)
ON or OFF
359
Front wiper(interval volume)
-
360
Wiper switch lever fail
No fail or Fail
361
Turn/Light switch lever fail
No fail or Fail
TROUBLE SYMPTOM CHART
M15410600017USA0000010000
Trouble symptom
Reference page
Malfunction of ETACS-ECU power supply circuit
54Ad-56
ETACS
DIAGNOSIS
SYMPTOM PROCEDURES
Malfunction of ETACS-ECU power supply circuit
M15410600019USA0000010000
ETACS-ECU Power Supply Circuit
FUSIBLE
LINK
36
FUSIBLE
LINK
34
ETACS-ECU
RELAY BOX
ENGINE
COMPARTMENT
ZC6008780016
Connectors: C-306, C-307, C-309, C-315, C-317
C-306
C-307 (B)
C-309 (B)
C-315
C-317
TECHNICAL DESCRIPTION (COMMENT)
If the ETACS-ECU functions do not work at all, the
ETACS-ECU power supply system, earth system, or
ETACS-ECU may have a problem.
TROUBLESHOOTING HINTS
⦆
The wiring harness or connectors may have loose,
corroded, or damaged terminals, or terminals
pushed back in the connector
⦆
The ETACS-ECU may be defective
ETACS
54Ad-57
DIAGNOSIS
DIAGNOSIS
Required Special Tools:
⦆
MB991223: Harness Set
⦆
MB992006: Extra Fine Probe
STEP 1. Check ETACS-ECU connectors C-315 and C-317 for
loose, corroded or damaged terminals, or terminals pushed
back in the connector.
Q:Is ETACS-ECU connectors C-315 and C-317 in good
condition?
YES:
Go to Step 2.
NO:
Repair or replace the damaged component(s). Refer to
GROUP 00E, Harness Connector Inspection P.00E-2.
STEP 2. Check the ground circuit to the ETACS-ECU.
Measure the resistance at ETACS-ECU connectors C-315
and C-317.
(1)
Disconnect ETACS-ECU connector C-315 and C-317 and
measure the resistance available at the wiring harness side
of the connector.
ZC6022220000
Connector C-315
(Harness side)
(2)
Measure the resistance value between ETACS-ECU
connector C-315 terminal 17 and ground.
⦆
The resistance should be 2 ohms or less.
ZC6022220001
Connector C-317
(Harness side)
(3)
Measure the resistance value between ETACS-ECU
connector C-317 terminal 15 and ground.
⦆
The resistance should be 2 ohms or less.
Q:Is the measured resistance 2 ohms or less?
YES:
Go to Step 4.
NO:
Go to Step 3.
STEP 3. Check the wiring harness between ETACS-ECU
connector C-315 (terminal 17) or C-317 (terminal 15) and the
ground.
Q:Is the wiring harness between ETACS-ECU connector
C-315 (terminal 17) or C-317 (terminal 15) and the ground
in good condition?
YES:
No action is necessary and testing is complete.
NO:
The wiring harness may be damaged or the connector
(s) may have loose, corroded or damaged terminals, or
54Ad-58
ETACS
DIAGNOSIS
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст