Mitsubishi Outlander XL. Manual — part 54
Label area (x: for original equipment parts, y: for replacement parts)
ZC501871
View E (Hood)
x
y
0001
ZC501877
View F (Side outer panel)
The illustration indicates left outer side.
Right side is symmetrically opposite.
0000
x
ZC501877
View G (Side outer panel)
e
e
Section e - e
y
The illustration indicates left outer side.
Right side is symmetrically opposite.
0001
ZC5018760000
View H (Liftgate upper)
y
x
ZC501876
View I (Liftgate lower)
x
y
0001
GENERAL <BODY AND CHASSIS>
00-25
VEHICLE IDENTIFICATION CODE PLATE
PRECAUTIONS BEFORE SERVICE
SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
M10001000116USA0000010000
1.
Items to review when servicing SRS:
(1)
Be sure to read GROUP 52B, Supplemental
Restraint System (SRS). For safe operation,
please follow the directions and heed all
warnings.
(2)
Wait at least 60 seconds after disconnecting the
battery cable before doing any further work. The
SRS system is designed to retain enough
voltage to deploy the air bag even after the
battery has been disconnected. Serious injury
may result from unintended air bag deployment
if work is done on the SRS system immediately
after the battery cable is disconnected.
(3)
Warning labels must be heeded when servicing
or handling SRS components. Warning labels
can be found in the following locations.
⦆
Air bag module (driver’s and passenger’s)
⦆
Clock spring
⦆
SRS-ECU
⦆
Sunvisor
⦆
Seat belt with pre-tensioner (driver’s seat and
passenger’s seat)
⦆
Side-airbag module (driver’s seat and
passenger’s seat)
⦆
Curtain air bag module (right side and left
side)
⦆
Lap pre-tensioner (driver’s side)
⦆
Glove box
(4)
Always use the designated special tools and test
equipment.
(5)
Store components removed from the SRS in a
clean and dry place. The air bag module should
be stored on a flat surface and placed so that the
pad surface is facing upward.
(6)
Never attempt to disassemble or repair the SRS
components (SRS-ECU, air bag module and
clock spring). If there is a defect, replace the
defective part.
(7)
Whenever you finish servicing the SRS, check
the SRS warning light operation to make sure
that the system functions properly.
(8)
Be sure to deploy the air bag before disposing
of the air bag module or disposing of a vehicle
equipped with an air bag (Refer to GROUP 52B,
Air Bag Module and Seat Belt Pre-tensioner
Disposal Procedures P.52B-352).
2.
Observe the following when carrying out operations
on places where SRS components are installed,
including operations not directly related to the SRS
air bag.
(1)
When removing or installing parts, do not allow
any impact or shock to occur to the SRS
components.
(2)
If heat damage may occur during paint work,
remove the SRS-ECU, the air bag module, clock
spring, the front impact sensor, the side impact
sensor, and the seat belt pre-tensioner.
⦆
SRS-ECU, air bag module, clock spring, front
impact sensor, the side impact sensor: 93 °C
(200 °F) or more
⦆
Seat belt pre-tensioner: 90 °C (194 °F) or
more
HOW TO PERFORM VEHICLE IDENTIFICATION NUMBER (VIN) WRITING
M10001000114USA0000010000
The F.A.S.T-Key (Free-hand Advanced Security
Transmitter) is described as the Keyless
Operation System (KOS) in this manual.
Follow the procedure below to register the VIN of the
Wireless Control Module (WCM) and the Keyless
Operation System (KOS).
The VIN is stored in the engine control module (ECM),
WCM, and the KOS-ECU. If the VIN is improperly
erased, the engine warning light or the keyless
operation system warning indicator illuminate, and the
diagnostic trouble code is displayed. When the ECM,
WCM, and the KOS-ECU are replaced, follow the
procedure below to write the VIN.
00-26
GENERAL <BODY AND CHASSIS>
PRECAUTIONS BEFORE SERVICE
ZC6037920000
KOS/IMMO/Keyless/TPMS
KOS/IMMO/Keyless/TPMS
VIN Registration
VIN Registration
Confirmation
VIN Registration
completed
Result of VIN
Registration
Screen frow of M.U.T. - III
WRITING PROCEDURE
Required Special Tools:
⦆
MB991958: Scan Tool (M.U.T.-III Sub Assembly)
⦆
MB991824: V.C.I.
⦆
MB991827: M.U.T.-III USB Cable
⦆
MB991910: M.U.T.-III Main Harness A
Check that diagnostic trouble code P0603 "EEPROM fail" is
not set. When diagnostic trouble code P0603 "EEPROM fail"
is set, the ECM cannot store the key code even if the key
code is registered. If this diagnostic trouble code is set,
troubleshoot the ECM and repair. Then register the key code
to the ECM.
Check that diagnostic trouble code P0630 "VIN not
programmed" is not set. When diagnostic trouble code
P0630 "VIN not programmed" is set, the VIN is not written
to the ECM. After VIN is written in ECM, the Key Code
Registration is executed.
GENERAL <BODY AND CHASSIS>
00-27
PRECAUTIONS BEFORE SERVICE
ZC501967
AC404789
ZC5019680000
MB991824
MB991827
MB991910
Data link
connector
Connect scan tool MB991958 to the 16-pin data link connector
as follows.
NOTE:
For details on how to use scan tool MB991958, refer
to the "M.U.T.-III Owner's Manual."
1.
Ensure that the ignition switch is at the "LOCK" (OFF) position.
2.
Start up the personal computer.
3.
Connect special tool MB991827 to special tool MB991824 and
the personal computer.
4.
Connect special tool MB991910 to the special tool MB991824.
5.
Connect special tool MB991910 to the data link connector of
the vehicle.
6.
Turn the special tool MB991824 power switch to the "ON"
position.
NOTE:
When the special tool MB991824 is energized, the
special tool MB991824 indicator light will be illuminated
in a green color.
7.
Start the "M.U.T.-III system" on the personal computer and
turn the ignition switch to the "ON" position.
System Select
Select Model Year and System
System List
Model Yea r
Vehicle In fo r matio n
Loading Option Setup
OPC
With Option
Option Name
Model Name
Model Yea r
OUTLANDER
2007
Model Code
Up to 2005 MY
From to 2006 M
Y
1
2
3
4
5
6
7
8
9
10
MPI/GDI/Diesel
KOS/IMMOBI/ Keyless/TPM S
AT/CVT/A-M
T
ABS/ASC/ASTC
SAS
Multi Select 4WD
SRS Airbag
A/C
E TA C S
Meter
ZC6037850000
OK button
8.
Select "KOS/IMMO/Keyless/TPMS" button from the "System
Select" screen. Then, select the applicable option code item
and push the OK button.
9.
Select "Special Function" on the next screen.
System Select
Please select function.
Special Function
Key & KOS Key Reg .
Stee ring lo ck unit Reg .
Comm . Tes t
ENG Key Code Reg .
ZC6037860000
Vehicles for KOS
K OS/IMMO/
K e yless/TPM
S
Tire Pressure Sensor ID Che
ck
Tire Pressure Sensor ID Regist
ratio n
Tire Pressure Sensor Che
ck
Key (Barcode No) &
KOS Key Reg .
System Select
Please select function.
Special Function
Key Regist ratio n
Key Regist ration (Barcode N
o.)
Keyless ID Reg
.
ENG Key Code Reg .
ZC6037870000
Vehicles for WCM
K OS/IMMO/
K e yless/TPM
S
Additional ke y regist ratio n
Tire Pressure Sensor ID Che
ck
Tire Pressure Sensor ID Regist
ratio n
Tire Pressure Sensor Che
ck
10.
Select "ENG Key Code Reg." from the "Special Function"
screen.
00-28
GENERAL <BODY AND CHASSIS>
PRECAUTIONS BEFORE SERVICE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст