Mitsubishi Montero (2004+). Manual — part 799
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-453
STEP 33. Check the wiring harness between rear personal
light (LH) connector F-06 (terminal 3) and ground.
NOTE: Also check intermediate connectors D-26 for loose, cor-
roded, or damaged terminals, or terminals pushed back in the
connector. If intermediate connector D-26 is damaged, repair or
replace the damaged component(s) as described in GROUP,
Harness Connector Inspection
.
Q: Is the wiring harness between rear personal light (LH)
connector (terminal 3) and ground in good condition?
YES : No action to be taken.
NO : Repair the wiring harness. Verify that the rear
personal light (LH) illuminates normally.
STEP 34. Check the rear personal light (RH).
Q: Does the dome light illuminate when the rear personal
light (RH) switch is turned to the "ON" position?
YES : Go to Step 35.
NO : Go to Step 37.
AC204178
CONNECTOR : F-06
AQ
HARNESS SIDE
AC204170
CONNECTOR : D-26
AG
2 3
1
7
6
12
11
8
13
5
4
9 10
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-454
STEP 35. Check rear personal light (RH) connectors F-04
and ETACS-ECU connector D-222 for damage.
Q: Are rear personal light (RH) connector F-04 and
ETACS-ECU connector D-222 in good condition?
YES : Go to Step 36.
NO : Repair or replace the connector. Refer to GROUP
00E, Harness Connector Inspection
. Verify
that the rear personal light (RH) illuminates normally.
STEP 36. Check the wiring harness between rear personal
light (RH) connector F-04 (terminal 3) and ETACS-ECU
connector D-222 (terminal 18).
AC204174
CONNECTOR : D-222
AB
1
2
3
5
6
4
9 8
121110
13
15 14
16
17
7
19
20
18
JUNCTION BLOCK SIDE
D-222
AC204177
CONNECTOR: F-04
AO
HARNESS SIDE
F-04
AC204174
CONNECTOR : D-222
AB
1
2
3
5
6
4
9 8
121110
13
15 14
16
17
7
19
20
18
JUNCTION BLOCK SIDE
D-222
AC204177
CONNECTOR: F-04
AO
HARNESS SIDE
F-04
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-455
NOTE: Also check intermediate connector D-26 and junction
block connector D-207 for loose, corroded, or damaged termi-
nals, or terminals pushed back in the connector. If junction
block connector D-207 or intermediate connector D-26 is dam-
aged, repair or replace the damaged component(s) as
described in GROUP 00E, Harness Connector Inspection
.
Q: Is the wiring harness between rear personal light (RH)
connector F-04 (terminal 3) and ETACS-ECU connector
D-222 (terminal 18) in good condition?
YES : Replace the ETACS-ECU. Verify that the rear
personal light (RH) illuminates normally.
NO : Repair the wiring harness. Verify that the rear
personal light (RH) illuminates normally.
STEP 37. Check the rear personal light (RH) bulb.
Q: Is the rear personal light (RH) bulb in good condition?
YES : Go to Step 38.
NO : Replace the bulb. Verify that the rear personal light
(RH) illuminates normally.
STEP 38. Check rear personal light (RH) connector F-04 for
damage.
Q: Is rear personal light (RH) connector F-04 in good
condition?
YES : Go to Step 39.
NO : Repair or replace the connector. Refer to GROUP
00E, Harness Connector Inspection
. Verify
that the rear personal light (RH) illuminates normally.
AC204170
CONNECTOR : D-26
AG
2 3
1
7
6
12
11
8
13
5
4
9 10
AC204173
CONNECTOR : D-207
AB
HARNESS SIDE
1
2
3
4
AC204177
CONNECTOR: F-04
AO
HARNESS SIDE
F-04
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-456
STEP 39. Check the fusible link (1) line of the power supply
circuit to the rear personal light (RH). Test at rear personal
light (RH) connector F-04.
(1) Disconnect rear personal light (RH) connector F-04 and
measure the voltage available at the wiring harness side of
the connector.
(2) Measure the voltage between terminal 1 and ground.
• The measured value should be approximately 12 volts
(battery positive voltage).
Q: Does the measured voltage correspond with this range?
YES : Replace the rear personal light (RH). Verify that the
rear personal light (RH) illuminates normally.
NO : Go to Step 40.
STEP 40. Check the wiring harness between rear personal
light (RH) connector F-04 (terminal 1) and fusible link (1).
AC204177
CONNECTOR: F-04
AO
HARNESS SIDE
F-04
AC209365
AC209365
AC209365
(HARNESS SIDE)
CONNECTOR D-04
IP
ACX02274
FUSIBLE LINK (1)
AE
BATTERY
AC204177
CONNECTOR: F-04
AO
HARNESS SIDE
F-04
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст