Mitsubishi Montero (2004+). Manual — part 406
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-31
STEP 4. Check stoplight switch connector D-123 for
looser, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Are the connector and terminals in good condition?
YES : Go to Step 5.
NO : Repair or replace the damaged components. Refer to
GROUP 00E, Harness Connector Inspection
STEP 5. Measure the stoplight switch power supply
voltage at connector D-123 by backprobing.
(1) Do not disconnect connector D-123.
(2) Turn the ignition switch to the "ON" position.
(3) Measure the voltage between terminal 3 and ground by
backprobing.
• When the brake pedal is depressed, voltage should
measure battery positive voltage.
• When the brake pedal is not depressed, voltage should
measure less than 1 volt.
Q: Does the voltage measure the battery positive voltage
when the brake pedal is depressed, and measure one
volt or less when the pedal is released?
YES : Go to Step 8.
NO : Go to Step 6.
1
2
3
4
AC204682AB
CONNECTOR: D-123
D-123
1
2
3
4
AC204682AB
CONNECTOR: D-123
D-123
2
1
3
4
AC205055AB
D-123 HARNESS
CONNECTOR:
HARNESS SIDE
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-32
STEP 6. Check stoplight switch connector D-123,
intermediate connector D-125, intermediate connector
E-110 and PCM connector D-133 for looser, corroded or
damaged terminals, or terminals pushed back in the
connector.
1
2
3
4
AC204682AB
CONNECTOR: D-123
D-123
AC205043
CONNECTOR: D-125
D-125
AB
AC205045
6
1
7
2
9
8
10
3
5
12
11
4
1314
E-110
CONNECTOR: E-110
AB
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-33
Q: Are the connectors and terminals in good condition?
YES : Go to Step 7.
NO : Repair or replace the damaged components. Refer to
GROUP 00E, Harness Connector Inspection
AC205046
CONNECTOR: D-133
D-133(GR)
PCM
AB
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-34
STEP 7. Check the harness for an open circuit or damage
between stoplight switch connector D-123 terminal 3 and
PCM connector D-133 terminal 54.
Q: Is the harness wire in good condition?
YES : Go to Step 8.
NO : Repair or replace the harness wire.
1
2
3
4
AC204682AB
CONNECTOR: D-123
D-123
AC205046
CONNECTOR: D-133
D-133(GR)
PCM
AB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст