Mitsubishi Montero (2004+). Manual — part 404
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-23
STEP 9. Check the resistance of the ground circuit at
auto-cruise control switch connector D-227.
(1) Disconnect auto-cruise control switch connector D-227 and
measure at the harness side.
(2) Check the resistance between terminal 3 and ground.
• The resistance should measure less than 2 ohms.
Q: Is the resistance less than 2 ohms?
YES : Go to Step 5.
NO : Go to Step 10.
AC205038AB
D-227
CONNECTOR: D-227
1
2
3
AC205054 AB
D-227 HARNESS
CONNECTOR:
COMPONENT SIDE
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-24
STEP 10. Check auto-cruise control switch connector
D-227, intermediate connector D-230, clock spring
connector D-226, clock spring connector D-205,
intermediate connector E-110 and PCM connector D-136
for looser, corroded or damaged terminals, or terminals
pushed back in the connector.
1 2 3
5
4
6
AC205037
2
1
3
CONNECTORS: D-205, D-226, D-227, D-230
D-227
D-226
D-205(B)
D-227
D-226
D-205
D-230(B)
D-230
AB
AC205045
6
1
7
2
9
8
10
3
5
12
11
4
1314
E-110
CONNECTOR: E-110
AB
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-25
Q: Are the connectors and terminals in good condition?
YES : Go to Step 11.
NO : Repair or replace the damaged components. Refer to
GROUP 00E, Harness Connector Inspection
AC205040
CONNECTOR: D-136
PCM
AB
D-136(GR)
AUTO-CRUISE CONTROL
TSB Revision
ENGINE AND EMISSION CONTROL
17-26
STEP 11. Check the harness for damage between
auto-cruise control switch connector D-227 terminal 3 and
PCM connector D-136 terminal 146.
Q: Is the harness wire in good condition?
YES : Go to Step 5.
NO : Repair or replace the harness wire.
DTC 21: Cancel Latch Signal System
.
DTC SET CONDITIONS
The PCM communicates cancellation retention infor-
mation between the two microprocessors. This DTC
is set when cancellation retention information con-
tains inconsistency.
.
TROUBLESHOOTING HINTS (The most likely
causes for this code to be set are:)
Malfunction of the PCM.
DIAGNOSIS
.
Replace the PCM. (Refer to
.) Check that diagnostic
trouble code 21 is not set.
AC205038AB
D-227
CONNECTOR: D-227
AC205040
CONNECTOR: D-136
PCM
AB
D-136(GR)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст