Mitsubishi Montero (2004+). Manual — part 807
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-485
.
CIRCUIT OPERATION
When the theft-alarm system is triggered, the
ETACS-ECU sounds the theft-alarm horn and all the
vehicle horns.
.
TECHNICAL DESCRIPTION (COMMENT)
If the theft-alarm horn and the vehicle horns do not
sound when the theft-alarm system is triggered, the
ETACS-ECU may be defective.
.
TROUBLESHOOTING HINTS
• The theft-alarm horn may be defective
• The horn may be defective
• The theft-alarm horn relay may be defective
• The horn relay may be defective
• The ETACS-ECU may be defective
• The wiring harness or connectors may have
loose, corroded, or damaged terminals, or termi-
nals pushed back in the connector
DIAGNOSIS
Required Special Tool:
• MB991223: Harness Set
AC204167
CONNECTORS : A-04, A-17
A-17
AS
A-04(B)
AC204183
CONNECTORS : A-10X, A-11X
A-11X
A-10X
AK
AC204166
CONNECTORS : A-27, A-28
AJ
A-28(B)
A-27(B)
AC204170
CONNECTORS : D-27, D-28
BQ
D-28
D-27
AC204174
CONNECTOR : D-223
D-223(B)
AF
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-486
STEP 1. Check which horn is defective.
Check which horn does not sound when the theft-alarm system
is triggered.
Q: Which horn does not sound?
Theft-alarm horn : Go to Step 2.
Horns (high and low) : Go to Step 12.
Horn (high or low) : Go to Step 20.
Theft-alarm horn and all vehicle horns : Replace the
ETACS-ECU. All the vehicle horn (including the
theft-alarm horn) should sound when the theft-alarm
system is triggered.
STEP 2. Check the theft-alarm horn.
Connect the battery as shown, and check that the theft-alarm
horn sounds.
Q: Does the theft-alarm horn sound?
YES : Go to Step 3.
NO : Replace the theft-alarm horn. All the vehicle horn
(including the theft-alarm horn) should sound when
the theft-alarm system is triggered.
STEP 3. Check theft-alarm horn relay connector A-11X for
loose, corroded or damaged terminals, or terminals
pushed back in the connector.
Q: Is theft-alarm horn relay connector A-11X in good
condition?
YES : Go to Step 4.
NO : Repair or replace the damaged component(s). Refer
to GROUP 00E, Harness Connector Inspection
. All the vehicle horn (including the theft-alarm
horn) should sound when the theft-alarm system is
triggered.
ACX02352
AC204183
CONNECTOR : A-11X
RELAY BOX SIDE
AE
2 1
5
4
3
A-11X
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-487
STEP 4. Check the theft-alarm horn relay.
Q: Is the theft-alarm horn relay normal?
YES : Go to Step 5.
NO : Replace the theft-alarm horn relay. All the vehicle
horn (including the theft-alarm horn) should sound
when the theft-alarm system is triggered.
STEP 5. Check the fusible link (1) line of the power supply
circuit to the theft-alarm horn relay. Test at theft-alarm horn
relay connector A-11X.
(1) Disconnect theft-alarm horn relay connector A-11X and
measure the voltage available at the relay box side of the
connector.
(2) Measure the voltage between terminal 3 and ground, and
also between terminal 5 and ground.
• The voltage should be approximately 12 volts (battery
positive voltage).
Q: Is the measured voltage approximately 12 volts (battery
positive voltage)?
YES : Go to Step 7.
NO : Go to Step 6.
BATTERY
VOLTAGE
TESTER
CONNECTION
SPECIFIED
CONDITION
Not applied
4
− 5
Open circuit
1
− Battery (−)
terminal,
3
− Battery (+)
terminal
4
− 5
Less than 2 ohms
1
2 3
4
5
1
3
4
5
AC204637
RELAY SIDE
AB
THEFT-ALARM HORN RELAY
AC204183
CONNECTOR : A-11X
RELAY BOX SIDE
AE
2 1
5
4
3
A-11X
1
2
3
4
5
ACX01571AC
CONNECTOR A-11X
(RELAY BOX SIDE)
SYMPTOM PROCEDURES
TSB Revision
SIMPLIFIED WIRING SYSTEM (SWS)
54B-488
STEP 6. Check the wiring harness between theft-alarm
horn relay connector A-11X (terminals 3 and 5) and fusible
link (1).
Q: Is the wiring harness between theft-alarm horn relay
connector A-11X (terminals 3 and 5) and fusible link (1)
in good condition?
YES : Replace the ETACS-ECU. All the vehicle horn
(including the theft-alarm horn) should sound when
the theft-alarm system is triggered.
NO : The wiring harness may be damaged or the
connector(s) may have loose, corroded or damaged
terminals, or terminals pushed back in the connector.
Repair the wiring harness as necessary. All the
vehicle horn (including the theft-alarm horn) should
sound when the theft-alarm system is triggered.
STEP 7. Check theft-alarm horn connector A-04 for loose,
corroded or damaged terminals, or terminals pushed back
in the connector.
Q: Is theft-alarm horn connector A-04 in good condition?
YES : Go to Step 8.
NO : Repair or replace the damaged component(s). Refer
to GROUP 00E, Harness Connector Inspection
. All the vehicle horn (including the theft-alarm
horn) should sound when the theft-alarm system is
triggered.
ACX02274
FUSIBLE LINK (1)
AE
BATTERY
AC204183
CONNECTOR : A-11X
RELAY BOX SIDE
AE
2 1
5
4
3
A-11X
AC204167
CONNECTOR : A-04
HARNESS
SIDE
A-04(B)
A-04(B)
AB
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст