Mitsubishi Outlander GS45X. Manual — part 69

FOG LIGHT

TSB Revision

CHASSIS ELECTRICAL

54A-273

BULB REPLACEMENT

M1540400400643

CAUTION

Don't touch the bulb surface with bare hands or dirty
gloves. If the bulb surface (glass part) gets dirty, clean it
with alcohol or thinner immediately and dry well, and then
install it.
1. Remove the front fog light bezel and the front fog light

assembly. (Refer to

P.54A-273

.)

2. Disconnect the connector and withdraw the bulb.
3. After replacing the bulb, securely connect the connector,

and install the front fog light assembly and the front fog light
bezel.

REMOVAL AND INSTALLATION

M1540400500338

AC800929

Fog light bulb

AF

Post-installation operation
Check the beam direction of the fog light (Refer to Front Fog
Light Aiming

P.54A-271

).

AC900461AC

1

2

4

3

0.9 ± 0.1 N·m
8.0 ± 1.0 in-lb

Removal steps

<<

A

>>

1.

Fog light bezel

2.

Fog light assembly

3.

Bulb

4.

Fog light unit

Removal steps (Continued)

FOG LIGHT

TSB Revision

CHASSIS ELECTRICAL

54A-274

REMOVAL SERVICE POINT

.

<<A>> FOG LIGHT BEZEL REMOVAL

1. Turn the fog light bezel until it is locked.
2. Remove the fog light bezel from the front bumper.

INSPECTION

FOG LIGHT RELAY CHECK

M1540400700097

AC900214 AC

Fog light bezel

Battery voltage

Terminal
number

Normal
condition

Not energized

3

− 4

No
continuity

With current supply
[terminal 2 (+), terminal 1
(

−)]

Continuity
exists (2
ohms or
less)

AC703275

2

3

4

1

AB

Fog light relay

Fog light relay

A-14X

SIDE TURN-SIGNAL LIGHT

TSB Revision

CHASSIS ELECTRICAL

54A-275

SIDE TURN-SIGNAL LIGHT

REMOVAL AND INSTALLATION

M1541800200394

<SIDE TURN-SIGNAL LIGHT
INTEGRATED IN DOOR MIRROR TYPE>

Refer to GROUP 51

− Outside Mirror

P.51-120

.

REMOVAL SERVICE POINT <FENDER PANEL
ATTACHMENT TYPE SIDE TURN-SIGNAL LIGHT>

.

Push the side turn-signal light toward the vehicle rear to bend
the hook, and then remove by disengaging the tab from the
fender panel.

INSTALLATION SERVICE POINT <FENDER
PANEL ATTACHMENT TYPE SIDE TURN-SIGNAL
LIGHT>

.

Engage the claw to the fender panel to install the side turn sig-
nal light.

AC506856

Side turn-signal light

AC

Push

Forward of vehicle

AC506857

Hook

Claw

Fender
panel

AC

Forward of vehicle

REAR SIDE-MARKAER LIGHT

TSB Revision

CHASSIS ELECTRICAL

54A-276

REAR SIDE-MARKAER LIGHT

REMOVAL AND INSTALLATION

M1544600100013

AC703293AC

A

A

Section A – A

Claw

Claw

2

1

1.5 ± 0.2 N·m
14 ± 1 in-lb

3

1

Removal Steps

•

Rear corner bumper (Refer to
GROUP 51, Rear Bumper
Assembly

P.51-7

.)

1.

Rear side-marker light unit

2.

Socket assembly

3.

Bulb

Removal Steps (Continued)