Mitsubishi Outlander GS45X. Manual — part 1762
TRANSAXLE
TSB Revision
AUTOMATIC TRANSAXLE OVERHAUL
23D-55
CAUTION
Measure the end play at more than two locations and
obtain the average of the measurements.
26.Measure the clearance (A) of the 2-6 brake using the
following procedure. Refer to "SERVICE DATA" for the
specified 2-6 brake clearance.
(1) While compressing the drive plates, driven plates and
retaining plate, measure thickness L1 of the pack.
NOTE: If there is no appropriate plate, use the special
tool, MD998917
Compression load
[N (kgf)]
800
− 1800 (82 − 184)
AK603381
A
2-6 Brake
Retaining plate
Snap ring
One-way
clutch
AD
L1
L1
AK603382
Drive
plates
Driven
plates
Retaining plate
Retaining plate
AD
AK605056
AC
MD998917
L1
TRANSAXLE
TSB Revision
AUTOMATIC TRANSAXLE OVERHAUL
23D-56
(2) Measure distance L2 from the end face of the transaxle
case to the snap ring.
CAUTION
When measuring L3, use the same straight bar as used
when L2 is measured.
(3) Measure distance L3 from the end face of the side cover
to the 2-6 brake piston.
(4) Calculate the clearance using the following formula.
Clearance = L2 - (L1 + L3)
(5) Select an appropriate retaining plate so that the specified
clearance is obtained. Refer to "SERVICE DATA" for
selecting the retaining plate.
Standard value: 1.9
− 2.2 mm (0.07 − 0.09 in)
(For 2-6 brake clearance)
CAUTION
• Apply vaseline to the needle bearing before installation.
• Ensure that the needle bearing faces the correct direc-
tion.
27.Install the needle bearing on the RR carrier assembly.
28.Install the RR sun gear on the rear side.
AK603383
L2
AK603384
L3
AK603319
AK603318
TRANSAXLE
TSB Revision
AUTOMATIC TRANSAXLE OVERHAUL
23D-57
CAUTION
• Apply vaseline to the needle bearing before installation.
• Ensure that the needle bearing faces the correct direc-
tion.
29.Install the needle bearing on the RR sun gear on the rear
side.
30.Install the high clutch hub.
CAUTION
• Apply vaseline to the needle bearing before installation.
• Ensure that the needle bearing faces the correct direc-
tion.
31.Install the needle bearing on the reduction internal gear.
32.Install the reduction internal gear on the high clutch hub.
AK603317
AK603316
AK603315
AK603314
TRANSAXLE
TSB Revision
AUTOMATIC TRANSAXLE OVERHAUL
23D-58
CAUTION
• Apply vaseline to the needle bearing before installation.
• Ensure that the needle bearing faces the correct direc-
tion.
33.Install the needle bearing on the reduction internal gear.
34.Install the reduction carrier.
35.Install the reduction sun gear.
CAUTION
Measure the end play at more than two locations and
obtain the average of the measurements.
36.Measure the reduction sun gear end play (A) using the
following procedure. Refer to "SERVICE DATA" for the
specified reduction sun gear end play (A).
AK603313
AK603312
AK603311
AK603385
A
Reduction
Reduction
Spacer
Side cover
High clutch
drum
sun gear
carrier
AD
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст