Mitsubishi Outlander GS45X. Manual — part 94
RADIO AND CD PLAYER
TSB Revision
CHASSIS ELECTRICAL
54A-373
STEP 7. Check radio and CD player connector C-14 and
audio amplifier connector C-127 for loose, corroded or
damaged terminals, or terminals pushed back in the
connector.
Q: Are radio and CD player connector C-14 and audio
amplifier C-127 in good condition?
YES : Go to Step 8.
NO : Repair or replace the damaged component(s). Refer
to GROUP 00E, Harness Connector Inspection
STEP 8. Check the wiring harness between radio and CD
player connector C-14 (terminal 17) and audio amplifier
connector D-127 (terminal 3)
• Check the communication line for open circuit and short cir-
cuit.
NOTE: Also check intermediate connector C-22 for loose, cor-
roded, or damaged terminals, or terminals pushed back in the
connector. If intermediate connector C-22 is damaged, repair or
replace the connector as described in GROUP 00E, Harness
Connector Inspection
.
Q: Is the wiring harness between radio and CD player
connector C-14 (terminal 17) and audio amplifier
connector D-127 (terminal 3) in good condition?
YES : Go to Step 9.
NO : The wiring harness may be damaged or the
connector(s) may have loose, corroded or damaged
terminals, or terminals pushed back in the connector.
Repair the wiring harness as necessary.
STEP 9. Check the wiring harness between radio and CD
player connector C-14 (terminal 7) and audio amplifier
connector D-126 (terminal 34)
• Check the communication line for open circuit and short cir-
cuit.
NOTE: Also check intermediate connector C-22 for loose, cor-
roded, or damaged terminals, or terminals pushed back in the
connector. If intermediate connector C-22 is damaged, repair or
replace the connector as described in GROUP 00E, Harness
Connector Inspection
.
Q: Is the wiring harness between radio and CD player
connector C-14 (terminal 7) and audio amplifier
connector D-126 (terminal 34) in good condition?
YES : Go to Step 10.
NO : The wiring harness may be damaged or the
connector(s) may have loose, corroded or damaged
terminals, or terminals pushed back in the connector.
Repair the wiring harness as necessary.
RADIO AND CD PLAYER
TSB Revision
CHASSIS ELECTRICAL
54A-374
STEP 10. Retest the system
Replace the audio amplifier, then check that the audio sound is
output.
Q: Is the check result normal?
YES : The trouble can be an intermittent malfunction (Refer
to GROUP 00, How to use
Troubleshooting/inspection Service Points, How to
Cope with Intermittent Malfunction
NO : Replace the radio and CD player.
RADIO AND CD PLAYER
TSB Revision
CHASSIS ELECTRICAL
54A-375
INSPECTION PROCEDURE 3: No sound is heard from one of the speakers. <Vehicles without audio
amplifier>
CAUTION
Before replacing the radio and CD player, ensure
that the power supply circuit, the ground circuit
and the communication circuit are normal.
Speaker System Circuit
TWEETER
(RH)
RADIO AND CD PLAYER
REAR DOOR
SPEAKER (LH)
REAR DOOR
SPEAKER (RH)
FRONT DOOR
SPEAKER (RH)
FRONT DOOR
SPEAKER (LH)
TWEETER
(LH)
RADIO AND CD PLAYER
TSB Revision
CHASSIS ELECTRICAL
54A-376
.
COMMENTS ON TROUBLE SYMPTOM
If the sound is not output from one of the speakers,
the speaker, radio and CD player, communication
line from the radio and CD player to the speakers
may have a problem.
.
PROBABLE CAUSES
• Malfunction of speaker
• Malfunctions of radio and CD player
• Damaged harness wires and connectors
DIAGNOSIS
Required Special Tools:
• MB991223: Harness Set
• MB992006: Extra Fine Probe
• MB991958: Scan Tool (M.U.T.-III Sub Assembly)
• MB991824: Vehicle Communication Interface (V.C.I.)
• MB991827: M.U.T.-III USB Cable
• MB991910: M.U.T.-III Main Harness A
AC703148AI
Connectors: C-16, C-20, C-112, C-113
C-20
C-113 (BR)
C-16
C-112
AC702815 AN
Connectors: C-32, C-126, C-127
C-127 (BR)
C-126
C-32
AC702817 AO
Connector: D-21
AC702816AJ
Connector: D-36
AC703415AC
Connectors: E-02, E-04, E-10, E-14, E-17, E-24
E-02 (B)
E-14 (B)
E-17
E-24
E-10
E-04
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст