Mitsubishi Outlander GS45X. Manual — part 490
ENGINE ASSEMBLY
TSB Revision
ENGINE MECHANICAL <2.4L ENGINE>
11A-91
INSTALLATION SERVICE POINTS
.
>>A<< ENGINE ASSEMBLY INSTALLATION
1. Install special tool MB991956 to the cylinder head, and set
special tool MB991527 and the chains of special tool
MB991454 to the engine assembly to hold the engine
assembly.
2. Install the engine assembly, being careful not to pinch the
cables, hoses, or wiring harness connectors.
.
>>B<< ENGINE MOUNTING BRACKET
INSTALLATION
CAUTION
When supporting the engine and transaxle assembly with
a garage jack, be careful not to deform the engine oil pan.
1. Place a garage jack against the engine oil pan with a piece
of wood in between, and install the engine mounting bracket
while adjusting the position of the engine.
AC600152AC
MB991956
Oil control
valve
(inlet side)
AC506787
MB991527
MB991454
AB
MB991956
ENGINE ASSEMBLY
TSB Revision
ENGINE MECHANICAL <2.4L ENGINE>
11A-92
2. Install special tool engine hanger (MB991928 or MB991895)
which is used during installation of transaxle assembly to
hold the engine assembly (Refer to GROUP 23A, Transaxle
Assembly
3. Remove the garage jack which supports the engine
assembly.
.
>>C<< GROUNDING CABLE CONNECTION
1. Install the grounding cable in the direction shown in the
illustration.
2. Tighten the generator mounting bolt to the specified torque.
Tightening torque: 44
± 10 N⋅m (33 ± 7 ft-lb)
.
>>D<< A/C COMPRESSOR AND CLUTCH
ASSEMBLY INSTALLATION
Tighten A/C compressor and clutch assembly mounting bolts to
the specified torque in the order of number shown in the illus-
tration.
Tightening torque: 23
± 6 N⋅m (17 ± 4 ft-lb)
.
AC506487
AE
MB991527
MB991454
MB991928
MB991956
AC506484
MB991527
AE
MB991454
MB991956
MB991895
AC606264
AB
15˚
15˚
AC506759
AE
1
2
3
A/C compressor
and clutch assembly
ENGINE ASSEMBLY
TSB Revision
ENGINE MECHANICAL <2.4L ENGINE>
11A-93
>>E<< FUEL HIGH-PRESSURE HOSE
INSTALLATION
CAUTION
After connecting the fuel high-pressure hose, slightly pull
it in the pull-out direction to check that it is installed firmly.
In addition, check that there is approximately 1 mm (0.04
inch) play. After the check, install the stopper securely.
AC703087
Stopper
AB
NOTES
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст