Mitsubishi Outlander GS45X. Manual — part 1662
TRANSAXLE
TSB Revision
CONTINUOUSLY VARIABLE TRANSAXLE OVERHAUL
23B-37
66.Remove the planet carrier from the transaxle case.
67.Remove the needle bearing from the planet carrier.
CAUTION
Check if there is damage, deformation, burn marks or per-
manent sets of the dish plate, driven plate, snap ring, and
drive plate. Replace any defective part.
68.Using a flat blade screwdriver etc., remove the reverse
brake retaining plate, drive plate, driven plate, and dish plate
from the transaxle case.
CAUTION
• Set the spring compressor right on top of the spring of
spring retainer assembly.
• Do not remove the return spring from the spring
retainer assembly.
69.Using the special tool MB992139, compress the return
spring, and remove the snap ring from the transaxle case.
70.Remove the retaining plate and return spring assembly.
AK502248
AK502249
AK502250
AK502251
MB992139
AE
TRANSAXLE
TSB Revision
CONTINUOUSLY VARIABLE TRANSAXLE OVERHAUL
23B-38
CAUTION
Be careful. Do not use to much air pressure as this may
cause the reverse brake piston be stuck.
71.Feed the air in the oil hole shown in the diagram, and
remove the reverse brake piston from the transaxle case.
AK502252AD
AK502253
TRANSAXLE
TSB Revision
CONTINUOUSLY VARIABLE TRANSAXLE OVERHAUL
23B-39
IDENTIFICATION OF NEEDLE BEARINGS
AKA00547AD
B
A
C
D
TRANSAXLE
TSB Revision
CONTINUOUSLY VARIABLE TRANSAXLE OVERHAUL
23B-40
ASSEMBLY SERVICE POINT
CAUTION
When the outer races of reduction gear bearing and differ-
ential side bearing are removed, measure the mounting
bore diameters of outer race in the converter housing and
transaxle case, and replace the housing case or the CVT
assembly if the standard value is not satisfied. The stan-
dard values are listed in "SERVICE SPECIFICATIONS."
CAUTION
• Do not re-use the reverse brake piston.
• Apply transmission fluid when installing the reverse
brake piston.
1. Install the reverse brake piston, while turning it, on the
transaxle case.
2. Align the spring portion of spring retainer assembly with the
projections of the reverse brake piston, and install the spring
retainer assembly.
AK502253
AK502254AI
Spring
Spring retainer assembly
Protrusion
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст