Mitsubishi Outlander GS45X. Manual — part 1747
TRANSFER ASSEMBLY <AWD>
TSB Revision
AUTOMATIC TRANSAXLE
23C-293
REMOVAL AND INSTALLATION <Vehicles without S-AWC>
M1231006000602
REMOVAL SERVICE POINT
.
>>A<< TRANSFER ASSEMBLY REMOVAL
Move the engine and transaxle assembly toward the front of
the vehicle to make a gap between the engine/transaxle
assembly and the crossmember. Pull out the transfer assembly
through this gap.
Pre-removal and post-installation operation
• Under cover removal and installation
• Transmission fluid draining and refilling (Refer to
• Transfer oil draining and refilling (Refer to
.)
• Front exhaust pipe removal and installation (Refer to
GROUP 15
• Propeller shaft removal and installation (Refer to GROUP
.)
• Center member removal and installation (Refer to
GROUP 32
AC607808AG
1
2
3
69 ± 9 N·m
51 ± 6 ft-lb
69 ± 9 N·m
51 ± 6 ft-lb
50 ± 5 N·m
37 ± 3 ft-lb
50 ± 5 N·m
37 ± 3 ft-lb
90 ± 10 N·m
66 ± 7 ft-lb
53 ± 8 N·m
40 ± 5 ft-lb
4
(Transmission fluid)
N
Removal steps
•
Pressure hose assembly, return
tube B, Hose bracket (Refer to
GROUP 37
1.
Rear roll stopper
2.
Transaxle case rear roll stopper
bracket
•
Drive shaft RH and output shaft
(Refer to GROUP 26
.)
>>A<<
3.
Transfer assembly
4.
O-ring
Removal steps (Continued)
TRANSAXLE CONTROL MODULE (TCM)
TSB Revision
AUTOMATIC TRANSAXLE
23C-294
TRANSAXLE CONTROL MODULE (TCM)
REMOVAL AND INSTALLATION
M1231036600180
Pre-removal and post-installation operation
• Bottom cover assembly (driver’s side) removal and instal-
lation (Refer to GROUP 52A
− Instrument Panel Assem-
bly
.)
• Glove box assembly removal and installation (Refer to
GROUP 52A
− Instrument Panel Assembly
.)
AC702849AE
2
1
13 ± 2 N·m
115 ± 17 in-lb
13 ± 2 N·m
115 ± 17 in-lb
Removal steps
1.
TCM
2.
TCM bracket
AWC-ECU <Vehicles with S-AWC>
TSB Revision
AUTOMATIC TRANSAXLE
23C-295
AWC-ECU <Vehicles with S-AWC>
REMOVAL AND INSTALLATION
M1235005400018
S-AWC CONTROL MODE SELECTOR
<Vehicles with S-AWC>
REMOVAL AND INSTALLATION
M1235005600012
Refer to GROUP 52A
− Floor Console Assembly
Pre-removal and post-installation operation
Removal and installation of the bottom cover assembly
(driver's side) (Refer to GROUP 52A
− Instrument Panel
Assembly
).
AC900387AB
AWC-ECU
11 ± 4 N·m
7.0 ± 3.0 N·m
AC605753 AD
Drive mode
selector
S-AWC CONTROL MODE SELECTOR <Vehicles with S-AWC>
TSB Revision
AUTOMATIC TRANSAXLE
23C-296
S-AWC CONTROL MODE SELECTOR
INSPECTION
M1235005700019
Switch position
Terminal
number
Normal
conditions
NORMAL
1
− 2
Continuity
exists (2
Ω or
less).
2
− 3
No continuity
SNOW
1
− 2
No continuity
2
− 3
OFF ROAD
1
− 2
No continuity
2
− 3
Continuity
exists (2
Ω or
less).
AC506018
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст