Mitsubishi Outlander GS45X. Manual — part 1343
AWD-ECU
TSB Revision
ELECTRONIC CONTROL AWD
27C-95
RESISTANCE MEASUREMENT BETWEEN
ELECTRONIC CONTROL COUPLING SOLENOID
CONNECTOR TERMINALS
Disconnect the D-119 connector, and measure the resistance
value between the connector terminals on the electronic control
coupling side. If the measured resistance value is out of the
standard value range, replace the electronic control coupling.
(Refer to
Standard value: 2.2
− 4.0 Ω
AWD-ECU
REMOVAL AND INSTALLATION
M1274009200039
1
2
AC703685 AB
D-119
Electronic
control coupling
Pre-removal and post-installation operation
Removal and installation of the bottom cover assembly and
glove box (Refer to GROUP 52A
− Instrument Panel
Assembly
.)
AC809407AC
AWD-ECU
11 ± 4 N·m
97 ± 35 in-lb
7.0 ± 3.0 N·m
62 ± 26 in-lb
DRIVE MODE SELECTOR
TSB Revision
ELECTRONIC CONTROL AWD
27C-96
DRIVE MODE SELECTOR
REMOVAL AND INSTALLATION
M1274007900087
Refer to GROUP 52A
− Instrument Panel Assembly
DRIVE MODE SELECTOR CHECK
M1274008000065
AC703688AB
Drive mode
selector
Switch position
Terminal
number
Normal
conditions
2WD (FWD)
1
− 2
Continuity
exists (2 ohm
or less).
2
− 3
No continuity
4WD (AWD)
1
− 2
No continuity
2
− 3
LOCK
1
− 2
No continuity
2
− 3
Continuity
exists (2 ohm
or less).
AC703686AB
ELECTRONIC CONTROL COUPLING
TSB Revision
ELECTRONIC CONTROL AWD
27C-97
ELECTRONIC CONTROL COUPLING
REMOVAL AND INSTALLATION
M1274002100138
INSTALLATION SERVICE POINT
.
>>A<< ELECTRONIC CONTROL COUPLING
INSTALLATION
1. Check that the length of the electronic control coupling stud
bolt (A) is within the standard value range.
Standard value: 22.3
− 25.1 mm (0.88 − 0.99 inch)
2. If it exceeds either of the limits, clean the threads for the
electronic control coupling and replace the stud bolt.
Tightening torque: 15
± 3 N⋅m (11 ± 2 ft-lb)
Removal steps
1.
Propeller shaft assembly (Refer to
GROUP 25
− Propeller Shaft
.)
2.
Cover
3.
Breather hose connection
4.
Connector connection
5.
Bracket
6.
Electronic control coupling
7.
Washer
AC905472
1
3
4
6
AE
2
7
5
Differential
side
Electronic control
coupling side
Semi-drying sealant:
ThreeBond 1215, 1216, 1217 or
equivalent
48 ± 6 N·m
36 ± 4 ft-lb
9.8 ± 1.9 N·m
87 ± 17 in-lb
54 ± 5 N·m
40 ± 3 ft-lb
AC703699AB
A
Electronic control
coupling
NOTES
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст