Mitsubishi Lancer Evolution 8. Manual — part 108
EXTERIOR – REAR SPOILER
51-5
Rear Spoiler
Removal and Installation
Removal procedure
• Boot lid bumper
1. Cap
2. Rear spoiler
Double-sided tape: Generic products A: width 5 mm, thickness 0.8 mm,
B: width 5 mm, thickness 1.2 mm
Primer: Sumitomo 3M 8107 PP parts primer
Remarks :
The removal and installation service points are the same as those for the air dam, bumper moulding, wing and door moulding
in the previous model.
A
A
EXTERIOR – MARKS
51-6
Marks
Removal and Installation
1. Three diamond mark
A
2. LANCER mark
A
3. EVOLUTION mark
Installation service points
A
Installation of marks
1. Installation position
(2) LANCER mark
Boot lid end line
Boot lid end line
EXTERIOR – MARKS
51-7
(3) EVOLUTION mark
2. Installation procedure
(1) Remove grease from installation surface of the body, using unleaded
gasoline.
(2) Peel off the protective backing of the mark and apply it to the installation
position.
Caution
1) Perform this operation in a dust-free environment at a room temperature
of 20 – 38°C.
2) If the room temperature is less than 20°C, then the mark and body
(installation position) must be heated to 20 – 30°C.
3) The mark must be pressed to eliminate any air bubbles.
Boot lid end line
Boot lid end line
INTERIOR – GENERAL, BOOT INTERIOR TRIM, INTERIOR MIRROR 52A-1
SECTION 52A
CONTENTS
General
• The removal information for the boot interior trim has been changed due to the addition of a front trim.
• The removal information for the interior mirror has been changed due to design changes in the mirror.
Boot interior trim
General . . . . . . . . . . . . . ...1
Boot interior trim . . . . . . . . . ...1
Interior mirror . . . . . . . . . . . .1
Section A-A
Clip
Holder A
Cover
Holder B
Remarks
This symbol indicates the position of the clip
1. Rear end trim
2. Side trim lid
3. Side trim
4. Front trim
Interior Mirror
Removal procedure
1. Detach fitting at holder A, and pull cover down in direction of arrow 1.
2. Press holder B is direction of arrow 2 to disengage lock, and then pull
mirror down in direction of arrow 3.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст