Mitsubishi Lancer Evolution 8. Manual — part 183
INTAKE & EXHAUST – INLET MANIFOLD
16-2
Ignition devices
General
The following servicing information has been issued in conjunction with changes to the 4G63-MPI-T/C engine crank angle
sensor on the new Lancer Evolution VIII.
Other servicing information remains the same.
Crank angle sensor
Fitting and removal
CAUTION
When Brembo brake calipers are used, there is concern over paint peeling off, so when doing servicing work, make
sure they are not scratched by other components and tools. Furthermore, if any brake fluid gets onto the calipers, it
should be wiped off immediately.
Pre-removal and post-fitting operations
• Removal and fitting of timing belt (ref. Chapter 11A)
• Removal and fitting of radiator reservoir tank ASSY
• Removal and fitting of centre cover (ref. Chapter 11A – Camshaft, Valve Stem Seals)
INTAKE & EXHAUST – INLET MANIFOLD
16-3
Removal procedure
1. Power steering oil
pressure switch connector
2. Power steering oil pump heat protector
3. Power steering pump oil pump, bracket,
and oil reservoir ASSY
4. Power steering oil pump bracket
5. Crank angle sensor connector
6. Crank angle sensor
REMOVAL
A
Power steering oil pump, bracket, and oil reservoir ASSY removal
Remove the power steering oil pump, bracket, and oil reservoir, from the power
steering oil pump bracket, with the hose attached.
Note
The power steering oil pump, bracket, and oil reservoir ASSY which have been
removed, should be tied together, using something such as rope, so that they do
no interfere with the removal or fitting of the power steering oil pump bracket
A
ENGINE and EMISSION CONTROL – Emission Control <MPI>
SECTION 17
CONTENTS
EMISSION CONTROL <MPI>
General
These are based on the existing Lancer Evolution VII 4G63-DOHC-T/C engine control system, and the Exhaust Gas
Recirculation (EGR) devices have been deleted.
Other servicing information remains the same.
Emission control <MPI> . . . . . . . 1
General . . . . . . . . . . . . . . . . 1
On-vehicle servicing . . . . . . . . .2
System diagram . . . . . . . . . . . . ...2
Vacuum hose layout . . . . . . . . . . . .3
Checks . . . . . . . . . . . . . . . . .3
Exhaust gas cleaning device list . . . . . . ...4
17-1
ENGINE and EMISSION CONTROL – Emission Control <MPI>
17-2
On-vehicle servicing
System diagram
From the fuel tank
Check
valve
Canister
Vacuum
tank
Fuel pressure control
solenoid valve
Purge control
solenoid
valve
O2 sensor
To the
fuel tank
Fuel pressure
regulator
From the
fuel pump
PCV valve
Injector
Catalytic converter
Intake
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст