Dodge Journey (2019 year). Manual — part 30

NOTE:

1. You can replace “John Smith” with any name in your

mobile or favorite phone book. You can also say “Send
a message to John Smith” and the system will ask you
which phone number you want to send a message to for
John Smith.

2. You can replace “Mobile” with “Home,” “Work” or

“Other.”

3. You can replace “Incoming Calls” with “Outgoing

Calls” or “Missed Calls.”

4. Messaging commands only work if the Uconnect system

is equipped with this feature and the mobile phone
supports messaging over Bluetooth.

5. You can replace “248 555 1212” with any phone number

supported by your Mobile phone.

6. You can replace “4” with any message number shown

on the screen.

7. If your phone does not support phonebook download or

call log download over Bluetooth then these commands
will return a response that the contact does not exist in
the phonebook.

10

MULTIMEDIA

477

NOTE:

Available Voice Commands are shown in bold face

and underlined in the gray shaded boxes.

Uconnect Voice Command

478

MULTIMEDIA

General Information

The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:

This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, includ-

ing interference that may cause undesired operation.

Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.

RADIO OPERATION AND MOBILE PHONES

Under certain conditions, the mobile phone being on in
your vehicle can cause erratic or noisy performance from
your radio. This condition may be lessened or eliminated
by relocating the mobile phone antenna. This condition is
not harmful to the radio. If your radio performance does
not satisfactorily “clear” by the repositioning of the an-
tenna, it is recommended that the radio volume be turned
down or off during mobile phone operation when not
using Uconnect (if equipped).

10

MULTIMEDIA

479

Regulatory And Safety Information

USA/CANADA

Exposure to Radio Frequency Radiation

The radiated output power of the internal wireless radio is
far below the FCC and IC radio frequency exposure limits.
Nevertheless, the wireless radio will be used in such a
manner that the radio is 8 in (20 cm) or further from the
human body.

The internal wireless radio operates within guidelines
found in radio frequency safety standards and recommen-
dations, which reflect the consensus of the scientific com-
munity.

The radio manufacturer believes the internal wireless radio
is safe for use by consumers. The level of energy emitted is
far less than the electromagnetic energy emitted by wire-
less devices such as mobile phones. However, the use of
wireless radios may be restricted in some situations or
environments, such as aboard airplanes. If you are unsure
of restrictions, you are encouraged to ask for authorization
before turning on the wireless radio.

The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:

This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, in-

cluding interference that may cause undesired opera-
tion.

NOTE:

Changes or modifications not expressly approved

by the party responsible for compliance could void the
user’s authority to operate the equipment.

480

MULTIMEDIA

NOTE:
• This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interfer-
ence will not occur in a particular installation.

• If this equipment does cause harmful interference to

radio or television reception, which can be determined
by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of
the following measures:

1. Increase the separation between the equipment and

receiver.

2. Consult an authorized dealer or an experienced radio

technician for help.

VOICE COMMAND (UCONNECT 3/3 NAV)

Uconnect 3/3 NAV

The Uconnect Voice Command system allows
you to control your AM, FM radio, satellite radio,
disc player, SD Card, USB/iPod and SiriusXM
Travel Link.

The Uconnect Voice Command system allows you to
control your AM, FM radio, disc player, SD Card,
USB/iPod.

NOTE:

Take care to speak into the Voice Command system

as calmly and normally as possible. The ability of the Voice
Command system to recognize user voice commands may be
negatively affected by rapid speaking or a raised voice level.

WARNING!

Any voice commanded system should be used only in
safe driving conditions following all applicable laws,
including laws regarding phone use. Your attention
should be focused on safely operating the vehicle.
Failure to do so may result in a collision causing
serious injury or death.

10

MULTIMEDIA

481

When you push the Uconnect Voice Command

button,

you hear a beep. The beep is your signal to give a
command.

If no command is spoken the system says one of two
responses:
• I didn’t understand
• I didn’t get that, etc.
If a command is not spoken a second time, the system will
respond with an error and give some direction as what can
be said based on the context you are in. After three
consecutive failures of a spoken command the VR session
will end.

Pushing the Uconnect Voice Command

button while

the system is speaking is known as “barging in.” The
system will be interrupted, and after the beep, you can say
a command. This becomes helpful once you start to learn
the options.

NOTE:

At any time, you can say the words “Cancel” or

“Help.”

These commands are universal and can be used from any
menu. All other commands can be used depending upon
the active application.

When using this system, you should speak clearly and at a
normal speaking volume.

The system best recognizes your speech if the windows are
closed, and the heater/air conditioning fan is set to low.

At any point, if the system does not recognize one of your
commands, you will be prompted to repeat it.

To hear available commands, push the Uconnect Voice
Command

button and say “Help.” You hear available

commands for the screen displayed.

Natural Speech
Natural speech allows the user to speak commands in
phrases or complete sentences. The system filters out
certain non-word utterances and sounds such as “ah” and
“eh.” The system handles fill-in words such as “I would
like to.”

The system handles multiple inputs in the same phrase or
sentence such as “make a phone call” and “to Kelly Smith.”
For multiple inputs in the same phrase or sentence, the
system identifies the topic or context and provides the

482

MULTIMEDIA

associated follow-up prompt such as “Who do you want to
call?” in the case where a phone call was requested but the
specific name was not recognized.

The system utilizes continuous dialog; when the system
requires more information from the user it will ask a
question to which the user can respond without pressing
the Uconnect Voice Command

button.

Uconnect Voice Commands

The Uconnect Voice Command system understands two
types of commands. Universal commands are available at
all times. Local commands are available if the supported
radio mode is active.

Start a dialogue by pushing the Uconnect Voice Command

button.

Changing The Volume

1. Start a dialogue by pushing the Voice Command

but-

ton.

2. Say a command (e.g., “Help”).

3. Use the ON/OFF VOLUME rotary knob to adjust the

volume to a comfortable level while the Voice Com-
mand system is speaking. Please note the volume set-
ting for Voice Command is different than the audio
system.

Starting Voice Recognition (VR) Session In
Radio/Player Modes

In this mode, you can say the following commands:

NOTE:

The commands can be said on any screen when a

call is not active after pushing the Uconnect Voice Com-
mand

button.

Source

To switch to the audio source, say “Change source to Disc”
for example. This command can be given in any mode or
screen:
• “Track” (#) (to change the track)

10

MULTIMEDIA

483

Voice Tree

Uconnect Voice Commands - AM/FM/Satellite

484

MULTIMEDIA

NOTE:
• You can replace “950 AM” with any other AM or FM

frequency, such as “98.7 FM.”

• You can replace “80’s on 8” with any other station name

received by the radio.

• You can replace “8” with any other channel number

received by the radio.

• You can replace “rock” with any of the music types.
• Available Voice Commands are shown in bold face and

shaded grey.

10

MULTIMEDIA

485

Uconnect Hands-Free Music Control

486

MULTIMEDIA

NOTE:
• You can replace the album, artist, song, genre, playlist,

podcast and audio book names with any corresponding
names on the current device that is playing.

• You can replace “8” with any track on the CD that is

currently playing. Command is only available when CD
is playing.

• Playlist, Podcast and audio book commands are only

available when the iPod is connected and playing.

• VR commands, Albums, Artists, and Genre names are

based on the music metadata contained on the loaded/
connected device.

• Available Voice Commands are shown in bold face and

shaded grey.

10

MULTIMEDIA

487

Uconnect Voice Command - Travel Link

488

MULTIMEDIA

NOTE:
• You can replace “NFL” with any league shown on the

sports league screen. For example you can say “Show
MLB headlines” or “Show PGA headlines.”

• You can replace “Headlines” with any menu items

shown on a league screen. For example you can say
“Show NFL Schedule and results” or “Show NCAA
Basketball AP top 25” or “Show Major League Baseball
Teams.”

• You can also say “Show Current Weather” or “Show

extended weather” or “Show five day forecast” or
“Show ski info” to get other forecasts.

• Available Voice Commands are shown in bold face and

shaded grey.

10

MULTIMEDIA

489

Uconnect Voice Command - Non-Phone

490

MULTIMEDIA

NOTE:
• Only available with Navigation equipped vehicles.
• You can replace “Player” with “Radio,” “Navigation,”

“Phone,” “Climate,” “More” or “Settings.”

• Navigation commands only work if equipped with

Navigation.

• Available Voice Commands are shown in bold face and

shaded grey.

10

MULTIMEDIA

491

Uconnect Voice Command - Navigation

492

MULTIMEDIA