Dodge Dakota (ND). Manual — part 1174

3. Loosen the glass clamp screws (2).

4. Raise the glass into the full up position and secure

into place with tape or equivalent.

5. Remove the two lower regulator bolts (3).

6. Remove the one bolt at the crank mechanism.

7. Loosen the remaining three regulator bolts (2)

located at the keyhole slots.

8. Lift regulator up and out of the keyhole slots and

remove from door.

INSTALLATION

1. Place the regulator into the door and engage the

bolts into the keyhole slots in the door.

2. Install the regulator lift mechanism bolt.

3. Install the two lower bolts (3).

4. Tighten all the regulator bolts to 10 N·m (85 in.

lbs.).

23 - 108

DOORS - REAR

ND

5. Remove the tape used to secure the glass during

removal and position the glass (1) into the glass
clamps.

6. Temporarily install the window crank handle and

raise the glass into the full up position.

7. Tighten the glass clamp screws (2) securely.

8. Remove the manual window crank and install the

watershield. (Refer to 23 - BODY/DOORS - REAR/
WATERSHIELD - INSTALLATION)

ND

DOORS - REAR

23 - 109

REGULATOR-WINDOW - POWER

REMOVAL

1. Remove the watershield. (Refer to 23 - BODY/

DOORS - REAR/WATERSHIELD - REMOVAL)

2. Temporarily install the window switch and position

the glass (1) to gain access to the glass clamp
screws (4).

23 - 110

DOORS - REAR

ND

3. Loosen the glass clamp screws (2).

4. Raise the glass (1) into the full up position and

secure into place with tape or equivalent.

5. Disconnect the electrical connector (3).

6. Remove the two lower regulator bolts and the one

bolt at the motor (4).

7. Loosen the remaining three regulator bolts (2)

located at the keyhole slots.

8. Lift regulator (1) up and out of the keyhole slots

and remove from door.

ND

DOORS - REAR

23 - 111