Dodge Dakota (ND). Manual — part 1212
Quad Cab
1. Using a trim stick C-4755 or equivalent, disengage
the retaining tabs (2) that secure the rear door sill
scuff plate (1) to the retaining clips in the rear door
sill and remove the scuff plate.
INSTALLATION
Club Cab
1. Align the retaining tabs (2) on the rear door sill
scuff plate (1) with the retaining clips in the rear
door sill and engage the retaining tabs that secure
the scuff plate to the door sill.
23 - 260
INTERIOR
ND
2. Align the retaining tabs (2) on the door sill scuff
plate end of the cowl trim panel with the retaining
clips in the front door sill and engage the retaining
tabs that secure the trim panel to the door sill.
3. Install the outer front seat belt retractor cover,
(Refer to 23 - BODY/INTERIOR/COVER-OUTER
FRONT
SEAT
BELT
RETRACTOR
-
INSTALLATION).
ND
INTERIOR
23 - 261
Quad Cab
1. Align the retaining tabs (2) on the rear door sill
scuff plate (1) with the retaining clips in the rear
door sill and engage the retaining tabs that secure
the scuff plate to the door sill.
SHIFT BOOT-FLOOR
REMOVAL
1. Using a small flat-bladed tool, remove the insert (1)
from the top of the gear shift knob (2).
2. Remove the nut (3) that secures the gear shift
knob to the gear shift lever (4).
3. Remove the gear shift knob.
4. Using a trim stick C-4755 or equivalent, disengage
the retaining tabs that secure the gear shift boot (5)
to the floor console (6) and remove the boot.
23 - 262
INTERIOR
ND
INSTALLATION
1. Position the gear shift boot (5) over the gear shift
lever (4).
2. Engage the retaining tabs that secure the gear shift
boot to the floor console (6).
3. Install the gear shift knob (2) onto the gear shift
lever.
4. Install the nut (3) that secures the gear shift knob
to the gear shift lever. Tighten the nut to 27 N·m
(20 ft. lbs.).
5. Install the insert (1) into the top of the gear shift
knob.
SUN VISOR
REMOVAL
1. Disengage the sun visor (2) from the sun visor sup-
port.
2. Remove the two screws that secure the sun visor
to the roof panel and remove the sun visor from
the headliner (1).
3. If equipped, disconnect the illuminated vanity mirror
wire harness connector.
ND
INTERIOR
23 - 263
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст