Dodge Dakota (ND). Manual — part 37
8. Install bolts into two of the threaded holes in the
companion flange 180° apart.
9. Position Holder 6719 against the companion flange
and install a bolt and washer into one of the
remaining threaded holes. Tighten the bolts so that
the Holder 6719 is held to the flange.
10. Remove pinion nut.
11. Remove companion flange (1) with Remover
C-452 (2).
12. Remove pinion from differential housing with a
hammer (1).
3 - 64
FRONT AXLE - C205F
ND
13. Remove pinion seal with a pry tool or a slide
hammer mounted screw.
14. Remove oil slinger, if equipped, and front pinion
bearing.
15. Remove front pinion bearing cup with Remover
D-103 (1) and Handle C-4171 (2).
16. Remove rear pinion bearing cup with Remover
8401 (1) and Handle C-4171 (2).
ND
FRONT AXLE - C205F
3 - 65
17. Remove collapsible preload spacer (1).
18. Remove rear pinion bearing from pinion shaft (4)
with Puller C-293-PA (1) and Adapters C-293-42
(3).
19. Remove depth shims from pinion shaft and record
shim thickness.
3 - 66
FRONT AXLE - C205F
ND
INSTALLATION
NOTE: The ring gear and pinion are serviced in a
matched set. Never replace one gear without
replacing the other. If ring and pinion gears or
bearings are replaced, Refer to Adjustments for
Pinion Gear Depth Setting.
1. Apply Mopar Door Ease or equivalent lubricant to
outside surface of the bearing cups.
2. Install rear pinion bearing cup with Installer D-145
(1) and Handle C-4171 (2).
3. Install front pinion bearing cup with Installer D-129
(1) and Handle C-4171 (2).
4. Install
pinion
front
bearing
and
oil
slinger
if
equipped.
5. Apply a light coating of gear lubricant on the lip of
pinion seal.
6. Install pinion seal with an appropriate installer (2)
and handle (1).
ND
FRONT AXLE - C205F
3 - 67
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст