Dodge Dakota (ND). Manual — part 1031
P0770-4C SOLENOID CIRCUIT (CONTINUED)
5.
(T259) 4C SOLENOID CONTROL CIRCUIT OPEN
Connect Miller tool #8815 to the PCM C4 harness connector.
CAUTION: Do not probe the PCM harness connectors. Probing
the PCM harness connectors will damage the PCM terminals
resulting in poor terminal to pin connection. Install Miller special
tool #8815 to perform diagnosis.
Measure the resistance of the (T259) 4C Solenoid Control circuit from
the Transmission Solenoid/TRS Assembly harness connector to the
appropriate terminal of Miller tool #8815.
Is the resistance above 5.0 ohms?
Yes
>> Repair the (T259) 4C Solenoid Control circuit for an open.
Perform 45RFE/545RFE TRANSMISSION VERIFICATION
TEST - VER 1.
No
>> Go To 6
6.
(T259) 4C SOLENOID CONTROL CIRCUIT SHORT TO GROUND
Measure the resistance between ground and the (T259) 4C Solenoid
Control circuit.
Is the resistance below 5.0 ohms?
Yes
>> Repair the (T259) 4C Solenoid Control circuit for a short to
ground.
Perform 45RFE/545RFE TRANSMISSION VERIFICATION
TEST - VER 1.
No
>> Using the schematics as a guide, check the Powertrain
Control Module (PCM) terminals for corrosion, damage, or
terminal push out. Pay particular attention to all power and
ground circuits. If no problems are found, replace the PCM
per the Service Information. With the scan tool, perform
QUICK LEARN.
Perform 45RFE/545RFE TRANSMISSION VERIFICATION
TEST - VER 1.
21 - 516
AUTOMATIC TRANSMISSION 545RFE - ELECTRICAL DIAGNOSTICS
ND
P0841-LR PRESSURE SWITCH RATIONALITY
ND
AUTOMATIC TRANSMISSION 545RFE - ELECTRICAL DIAGNOSTICS
21 - 517
P0841-LR PRESSURE SWITCH RATIONALITY (CONTINUED)
For the Transmission circuit diagram (Refer to 21 - TRANSMISSION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE -
SCHEMATICS AND DIAGRAMS).
For a complete wiring diagram Refer to Section 8W
•
When Monitored:
Continuously with the ignition on and engine running.
•
Set Condition:
The DTC will set if the L/R Pressure Switch reads open or closed at the wrong time in a given gear.
Possible Causes
LOSS OF PRIME AND/OR TRANSMISSION CONTROL RELAY DTC PRESENT
LOW FLUID LEVEL
LOW LINE PRESSURE
REVERSE CARRIER SNAP RING DISLODGED
CRACKED OR MISINSTALLED PRIMARY OIL FILTER OR FILTER SEAL
STICKING MAIN REGULATOR VALVE IN PUMP VALVE BODY
NO. 1 CHECK BALL CUT OR DAMAGED
WIRING AND CONNECTORS
(T50) L/R PRESSURE SWITCH SENSE CIRCUIT OPEN
(T50) L/R PRESSURE SWITCH SENSE CIRCUIT SHORT TO GROUND
(T50) L/R PRESSURE SWITCH SENSE CIRCUIT SHORT TO VOLTAGE
TRANSMISSION SOLENOID/TRS ASSEMBLY
POWERTRAIN CONTROL MODULE
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. (Refer to 21 - TRANSMIS-
SION/TRANSAXLE/AUTOMATIC - 45RFE/545RFE - DIAGNOSIS AND TESTING).
Theory of Operation
The Transmission system uses five pressure switches to monitor the fluid pressure in the L/R, 2C, 4C, UD, and OD
clutch circuits. The pressure switches are continuously monitored for the correct states in each gear as shown.
GEAR
L/R
2C
4C
UD
OD
REVERSE
OPEN
OPEN
OPEN
OPEN
OPEN
P/N
CLOSED**
OPEN
OPEN
OPEN
OPEN
1ST
CLOSED*
OPEN
OPEN
CLOSED
OPEN
2ND
OPEN
CLOSED
OPEN
CLOSED
OPEN
2ND PRIME
OPEN
OPEN
CLOSED
CLOSED
OPEN
3RD
OPEN
OPEN
OPEN
CLOSED
CLOSED
4TH
OPEN
OPEN
CLOSED
OPEN
CLOSED
5TH
OPEN
CLOSED
OPEN
OPEN
CLOSED
*L/R is closed if output speed is below 100 rpm in Drive and Manual 2. L/R is closed in Manual 1.
**May be open when rolling in Neutral or at low oil temperatures.
21 - 518
AUTOMATIC TRANSMISSION 545RFE - ELECTRICAL DIAGNOSTICS
ND
P0841-LR PRESSURE SWITCH RATIONALITY (CONTINUED)
Diagnostic Test
1.
OTHER RELATED DTC’S PRESENT
Ignition on, engine not running.
With the scan tool, check for other transmission DTC’s.
Are there any Loss of Prime and/or Transmission Control Relay related DTC’s present?
Yes
>> Refer to the Transmission category and perform the appropriate symptom. If the DTC P0944 is present,
perform its respective test first.
Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST - VER 1.
No
>> Go To 2
2.
CONDITION P0841 PRESENT
With the scan tool, check the EATX DTC EVENT DATA for P0841.
NOTE: Make sure to record all EATX DTC EVENT DATA stored in the scan tool for future reference in this
test procedure.
Does the EATX DTC EVENT DATA show the DTC P0841?
Yes
>> Go To 3
No
>> Refer to the Symptom Catagory and perform diagnostics for the DTC reported in the EATX DTC EVENT
DATA.
3.
DTC SET IN REVERSE
Does the EATX DTC EVENT DATA show the DTC P0841 set while in Reverse?
Yes
>> Go To 10
No
>> Go To 4
4.
L/R PRESSURE SWITCH CLOSED
Does the EATX DTC EVENT DATA show the L/R Pressure Switch reading CLOSED when the DTC P0841
was set?
Yes
>> Go To 5
No
>> Go To 14
ND
AUTOMATIC TRANSMISSION 545RFE - ELECTRICAL DIAGNOSTICS
21 - 519
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст