Dodge Dakota (ND). Manual — part 974
CAUTION: Failure to stake nut could allow the nut
to back-off during use.
19. The new nut (3) must be staked after the correct
turning torque is obtained. Use special tool 6639
(2) to stake output shaft nut.
20. Verify that the nut has been properly staked to the
output shaft.
21 - 288
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
ND
21. Install low/reverse clutch pack (1, 2). Leave
uppermost
disc
out
to
facilitate
snap
ring
installation.
22. Install low/reverse reaction plate snap ring (2).
23. Install one low/reverse clutch disc (1).
ND
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 289
24. Install low/reverse reaction plate (1) with flat side
up.
25. Install a new tapered snap ring (2) (tapered side
out).
21 - 290
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
ND
26. Make sure that the snap ring ends are oriented as
shown.
27. Measure low/reverse clutch pack. Set up dial indi-
cator (1) as shown. Press down clutch pack with
finger and zero dial indicator. Record measure-
ment in four (4) places and take average reading.
Low/Reverse clutch pack clearance is 0.84 to
1.60 mm (0.033 to 0.063 inch).
28. Select the proper low/reverse reaction plate to
achieve specifications.
ND
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 291
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст