Dodge Dakota (ND). Manual — part 177
5. Remove the right side front fender liner.
6. Unscrew the antenna mast from the antenna body.
7. Remove the antenna cap nut using an antenna nut
wrench (Special Tool C-4816)
8. Remove the antenna adapter from the top of the
fender.
9. Lower the antenna body through the mounting hole
in the top of the fender.
10. Disengage the antenna coaxial cable grommet
from the hole in the right cowl side outer panel.
11. Pull the antenna body and cable out through the
opening between the right cowl side outer panel
and the fender.
8A - 166
AUDIO/VIDEO - SERVICE INFORMATION
ND
INSTALLATION
1. Position the antenna body and cable in the opening
between the right cowl side outer panel and the
fender.
2. Push the antenna coaxial cable into the passenger
compartment through the hole in the right cowl side
outer panel.
3. Engage the antenna coaxial cable grommet in the
hole in the right cowl side outer panel.
4. Position the antenna body through the mounting
hole in the top of the fender.
5. Install the adapter over the antenna body from the
top of the fender.
6. Install and tighten the antenna cap nut using an
antenna nut wrench (Special Tool C-4816).
7. Install and tighten the antenna mast onto the
antenna body.
ND
AUDIO/VIDEO - SERVICE INFORMATION
8A - 167
8. Engage the antenna coaxial cable retainers at the
right cowl side inner panel and inside the right front
fender.
9. Engage the antenna coaxial cable in the retainer
clips on the lower instrument panel support and the
glovebox.
10. Reach under the instrument panel outboard of the
glove box to reconnect the antenna coaxial cable
connector.
11. Install the right cowl side trim panel.
12. Install the right side front fender liner.
13. Connect the battery negative cable.
8A - 168
AUDIO/VIDEO - SERVICE INFORMATION
ND
ANTENNA CABLE- INSTRUMENT PANEL
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the right cowl side trim panel.
3. Reach under the instrument panel outboard of the
glove box to access and disconnect the antenna
coaxial cable connector. Disconnect the connector
by pulling it apart while twisting the metal connec-
tor halves. Do not pull on the cable.
4. Disengage the instrument panel antenna cable
from the retainer clips on the glove box opening
and instrument panel support.
ND
AUDIO/VIDEO - SERVICE INFORMATION
8A - 169
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст