Dodge Dakota (ND). Manual — part 970
34. Remove the front sun gear assembly (1) and #4
thrust washer (if still in place).
35. Remove the front carrier/rear annulus (2) and #6
needle bearing (1).
36. Remove the rear sun gear (2) and #7 needle
bearing (1).
21 - 272
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
ND
NOTE: The number seven needle bearing (1) has
three antireversal tabs and is common with the
number five and number two position. The orien-
tation should allow the bearing to seat flat against
the rear sun gear. A small amount of petrolatum
can be used to hold the bearing to the rear sun
gear.
NOTE: Verify that Tool 5058A (1) is centered prop-
erly over the 2/4 clutch retainer (4) before com-
pressing. If necessary, fasten the 5058A bar to the
bellhousing flange with any combination of lock-
ing pliers and bolts to center the tool properly.
37. Install and load Tool 5058A to remove the 2/4
clutch retainer snap ring (3).
NOTE: The 2/4 Clutch Piston has bonded seals
which
are
not
individually
serviceable.
Seal
replacement requires replacement of the piston
assembly.
38. Remove the 2/4 clutch retainer (1).
ND
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 273
39. Remove the 2/4 clutch return spring (1).
40. Remove the 2/4 clutch pack (1, 2).
41. Remove the tapered snap ring (4).
21 - 274
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
ND
42. Remove the low/reverse reaction plate (1).
43. Remove one (1) low/reverse clutch disc to facili-
tate snap ring removal.
44. Remove the low/reverse reaction plate snap ring
(2).
ND
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 275
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст