Dodge Dakota (ND). Manual — part 1165
CAUTION: The door trim panel is attached to the
door by molded plastic retaining clips that are
integral to the door trim panel. Do not pull the
door trim panel directly off of the door or damage
to the trim panel and/or the power switch assem-
bly will occur.
4. Position the door trim panel (3) and align the
molded plastic retaining clips (6) to the door.
5. Lift the trim panel up and onto the lock rod (1) and
attachment hooks (6).
6. Push the door trim panel straight downward until all
of the retaining clips are fully engaged to the door.
7. Install the lower screws (5).
8. Install the screw (4) from the pull cup.
9. Install the screw (2) at the interior handle.
10. Install the manual window crank handle (2), if
equipped.
11. Connect battery negative cable.
REGULATOR-WINDOW - MANUAL
REMOVAL
1. Remove the watershield. (Refer to 23 - BODY/
DOOR - FRONT/WATERSHIELD - REMOVAL)
23 - 72
DOOR - FRONT
ND
2. Reinstall the manual window crank and raise the
door glass to the position shown (2).
3. Loosen the glass clamp screws (2).
4. Raise the glass into the full up position and secure
into place with tape or equivalent.
5. Remove the two lower regulator bolts (5).
6. Remove the one bolt (1) at the crank mechanism
(4).
7. Loosen the remaining three regulator bolts (3)
located at the keyhole slots.
8. Lift regulator up and out of the keyhole slots and
remove from door.
ND
DOOR - FRONT
23 - 73
INSTALLATION
1. Place the regulator into the door and engage the
bolts (5 and 3) into the keyhole slots in the door.
2. Install the regulator mechanism bolt (1).
3. Install the two lower bolts (5).
4. Tighten all the regulator bolts to 10 N·m (85 in.
lbs.).
5. Remove the tape used to secure the glass during
removal and position the glass (1) into the glass
clamps.
6. Temporarily install the window crank handle and
raise the glass into the full up position.
7. Tighten the glass clamp screws (2) securely.
8. Remove the manual window crank and install the
watershield. (Refer to 23 - BODY/DOOR - FRONT/
WATERSHIELD - INSTALLATION)
23 - 74
DOOR - FRONT
ND
REGULATOR-WINDOW - POWER
REMOVAL
1. Remove the watershield. (Refer to 23 - BODY/
DOOR - FRONT/WATERSHIELD - REMOVAL)
2. Temporarily install the window switch and position
the glass (1) to gain access to the glass clamp
screws(4).
ND
DOOR - FRONT
23 - 75
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст