Dodge Dakota (ND). Manual — part 1005
12. Install the transfer plate-to-valve body screws (1)
and torque to 5 N·m (45 in. lbs.).
13. Install the stiffener plate (1).
14. Install the solenoid/pressure switch assembly (1)
and screws to the transfer plate and torque to 5.5
21 - 412
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
ND
N·m (50 in. lbs.).
15. Install the manual shaft/rooster comb (3) and
transmission range sensor (1) to the valve body.
16. Install the TRS/manual shaft retaining screw (1)
and torque to 5 N·m (45 in. lbs.).
17. Install manual shaft seal.
ND
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 413
INSTALLATION
1. Install valve body into position and start bolts (1).
Torque valve body to transmission case bolts (1) to
12 N·m (105 in. lbs.) torque.
2. Install transmission oil filter (1).
21 - 414
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
ND
NOTE: Before installing the oil pan bolt in the bolt
hole (5) located between the torque converter
clutch on and U/D clutch pressure tap circuits , it
will be necessary to replentish the sealing patch
on the bolt using Mopar
T
Lock & Seal Adhesive.
3. Make sure oil pan (1) and case rail are clean and
dry. Install an 1/8” bead of RTV to the transmission
oil pan and install to case. Tighten bolts (2) to 20
N·m (14.5 ft. lbs.).
4. Lower vehicle and connect the TRS connector.
5. Connect solenoid/pressure switch assembly con-
nector.
6. Lower vehicle.
7. Fill transmission with ATF+4, Automatic Transmis-
sion Fluid. Verify proper fluid level. (Refer to 21 -
TRANSMISSION/AUTOMATIC - 42RLE/FLUID -
STANDARD PROCEDURE)
NOTE: If the valve body has been reconditioned or
replaced, it is necessary to perform the Quick
Learn Procedure. (Refer to 8 - ELECTRICAL/ELEC-
TRONIC
CONTROL
MODULES/TRANSMISSION
CONTROL MODULE - STANDARD PROCEDURE)
ND
AUTOMATIC TRANSMISSION 42RLE - SERVICE INFORMATION
21 - 415
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст