Dodge Dakota (ND). Manual — part 46
BEARINGS-DIFFERENTIAL CASE
REMOVAL
1. Remove differential case (4).
2. Remove
differential
bearings
(3)
with
Puller
C-293-PA (1) and Adapters C-293-48 (2) and Plug
SP-3289 (5).
INSTALLATION
1. Install differential side bearings (3) with Installer
C-4340 (4) and Handle C-4171 (1).
2. Install differential case in axle.
3 - 100
REAR AXLE - 8 1/4
ND
GEAR-PINION/RING/TONE RING
REMOVAL
NOTE: The ring gear and pinion are serviced in a
matched set. Never replace one gear without
replacing the other matching gear.
1. Remove differential from the axle housing.
2. Mark the companion flange and propeller shaft for
installation alignment.
3. Disconnect propeller shaft from the companion
flange and tie propeller shaft to underbody.
4. Place differential case (1) in a suitable vise with
soft metal jaw protectors.
5. Remove ring gear (2) bolts from the differential
case.
6. Drive ring gear off the differential case with a soft
hammer (3).
7. Install bolts into two of the threaded holes in the
companion flange 180° apart.
8. Position Holder 6719 against the companion flange
and install a bolt and washer into one of the
remaining threaded holes. Tighten the bolts so the
Holder 6719 is held to the flange.
9. Hold companion flange with Holder 6719 and
remove companion flange nut and washer.
10. Remove the companion flange (1) with Remover
C-452 (2).
ND
REAR AXLE - 8 1/4
3 - 101
11. Remove pinion from housing with a soft hammer
(1).
12. Remove pinion seal with a pry tool or slide-ham-
mer mounted screw.
13. Remove oil slinger if equipped and front pinion
bearing.
14. Remove front pinion bearing cup with Remover
C-4345 (1) and Handle C-4171 (2).
3 - 102
REAR AXLE - 8 1/4
ND
15. Remove rear bearing cup from housing with
Remover C-4307 (1) and Handle C-4171 (2).
16. Remove collapsible preload spacer (1).
ND
REAR AXLE - 8 1/4
3 - 103
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст