Chrysler Le Baron, Dodge Dynasty, Plymouth Acclaim. Manual — part 125
Fig. 6 Remove or Install Valve Body
Fig. 7 Valve Body Removed
Fig. 8 Accumulators
Fig. 9 Accumulator
Fig. 10 Low/Reverse Accumulator Snap Ring
Fig. 11 Low/Reverse Accumulator Plug (Cover)
21 - 106
TRANSAXLE
Ä
Measuring input shaft end play before disassembly
will usually indicate when a #4 thrust plate change
is required, (except when major parts are replaced).
The #4 thrust plate is located behind the overdrive
clutch hub.
Attach a dial indicator to transaxle bell housing
with its plunger seated against end of input shaft
(Fig. 14).
Move input shaft in and out to obtain end play
reading. End play specifications are .13 to .64 mm
(.005 to .025 inch).
Record indicator reading for reference when reas-
sembling the transaxle.
Fig. 12 Low/Reverse Accumulator Piston
Fig. 13 Low/Reverse Accumulator
Fig. 14 Measure Input Shaft End Play
Fig. 15 Pump Attaching Bolts
Fig. 16 Install Tool C-3752
Ä
TRANSAXLE
21 - 107
CAUTION: Be sure input speed sensor is removed
before removing oil pump.
CAUTION:The cooler bypass valve must be re-
placed if a transaxle failure has occurred. Do not re-
use old valve or attempt to clean old valve. When
installing bypass valve, insert with O-ring end to-
wards rear of case.
Fig. 17 Remove Oil Pump
Fig. 18 Oil Pump Removed
Fig. 19 Oil Pump Gasket
Fig. 20 Remove Bypass Valve
Fig. 21 No.1 Caged Needle Bearing
Fig. 22 Input Clutches Assembly
21 - 108
TRANSAXLE
Ä
Fig. 23 Front Sun Gear Assembly
Fig. 24 Front Carrier and Rear Annulus Assembly
Fig. 25 Rear Sun Gear
Fig. 26 2/4 Clutch Retainer Snap Ring
Fig. 27 Remove 2/4 Clutch Retainer
Fig. 28 2/4 Clutch Retainer
Ä
TRANSAXLE
21 - 109
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст