Dodge Durango (HB). Manual — part 1383
5. Disconnect the electrical connector and remove the
tweeter.
6. Remove the switch panel if necessary.
INSTALLATION
1. Install the switch assembly.
HB
DOORS - REAR
23 - 45
2. Install the tweeter and connect the electrical con-
nector.
3. Position the trim panel (4) and connect the inside
handle actuator rod (1).
4. Connect the electrical connectors (6).
5. Lift the trim panel up and onto the lock rod (2) and
attachment hooks.
6. Install the screws (3 & 5).
23 - 46
DOORS - REAR
HB
WATERSHIELD
REMOVAL
CAUTION: Do not allow the watershield or adhe-
sive to become contaminated with dirt or other
foreign substances.
Do not damage the watershield during removal
and installation.
If the watershield becomes contaminated or dam-
aged, replace the watershield.
1. Remove the speaker. (Refer to 8 - ELECTRICAL/
AUDIO/SPEAKER - REMOVAL)
2. Remove the door trim panel. (Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - REMOVAL)
3. Separate the watershield from the inner door panel
and off of the latch linkages.
INSTALLATION
CAUTION: Do not allow the watershield or adhe-
sive to become contaminated with dirt or other
foreign substances.
Do not damage the watershield during removal
and installation.
If the watershield becomes contaminated or dam-
aged, replace the watershield.
1. Position
the
wire
harness
and
actuator
rods
through the holes in the watershield.
2. Secure the watershield to the inner door panel.
3. Install the speaker. (Refer to 8 - ELECTRICAL/AU-
DIO/SPEAKER - INSTALLATION)
4. Install the trim panel. (Refer to 23 - BODY/DOORS
- REAR/TRIM PANEL - INSTALLATION)
HB
DOORS - REAR
23 - 47
GLASS
REMOVAL
1. Remove the watershield. (Refer to 23 - BODY/
DOORS - REAR/WATERSHIELD - REMOVAL)
2. Separate the inner belt molding from the mounting
flange from the rear to the front.
3. Insert special tool #9093 (2) between the outer belt
molding (1) and glass at the rear.
4. Push down on outer belt molding (1) and rotate
upper part of tool (2) outward from vehicle then lift
up on molding (1) to disengage from locking tabs
(3) working from back to front.
NOTE: Typical outer belt molding design shown.
5. Slide molding out from under the side view mirror
and remove.
6. Temporarily install the window switch and position
the glass (1) to gain access (2) to the regulator
nuts (4).
7. Remove the nuts (4) and remove the glass (1).
23 - 48
DOORS - REAR
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст