Dodge Durango (HB). Manual — part 1382
HINGE
REMOVAL
1. Remove the door. (Refer to 23 - BODY/DOOR -
FRONT/DOOR - REMOVAL)
2. Using a grease pencil or equivalent, mark the out-
line of the door hinges on a-pillar end to aid instal-
lation.
3. Remove the bolts (5) and remove the hinges (2 &
4).
INSTALLATION
1.
If necessary, paint replacement door hinge before
installation.
2. Position door hinge (2 & 4) on hinge pillar using
alignment marks and install the bolts (5).
3. Tighten the bolts to 28 N·m (21 ft. lbs.) using the
sequence shown.
NOTE: Right hand door shown, left hand door
opposite.
4. Install the door. (Refer to 23 - BODY/DOOR -
FRONT/DOOR - INSTALLATION)
HB
DOOR - FRONT
23 - 41
STRIKER
REMOVAL
1. Using a grease pencil or equivalent, mark the posi-
tion of the striker (2).
2. Remove the bolts (1) and remove the striker.
INSTALLATION
1. Install the striker and install the bolts.
2. Tighten the bolts to 28 N·m (21 ft. lbs.).
3. Adjust the striker if needed. (Refer to 23 - BODY/
DOOR - FRONT/LATCH STRIKER - ADJUST-
MENTS)
23 - 42
DOOR - FRONT
HB
ADJUSTMENTS
ADJUSTMENT
1. Using a grease pencil or equivalent, mark the posi-
tion of the striker (2) to aid in adjustment.
2. Loosen the striker bolts (1).
3. Change the striker position to adjust the rear gap
and flush measurement. (Refer to 23 - BODY/
BODY STRUCTURE/GAP AND FLUSH - SPECIFI-
CATIONS)
4. Tighten the bolts to 28 N·m (21 ft. lbs.).
HB
DOOR - FRONT
23 - 43
DOORS - REAR
TABLE OF CONTENTS
page
page
PANEL-TRIM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
. . . . . . . . . . . . . . . . . . . . . . . . . 45
WATERSHIELD
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47
. . . . . . . . . . . . . . . . . . . . . . . . . 47
GLASS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 48
. . . . . . . . . . . . . . . . . . . . . . . . . 49
REGULATOR-WINDOW
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 49
. . . . . . . . . . . . . . . . . . . . . . . . . 50
HANDLE-EXTERIOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 52
. . . . . . . . . . . . . . . . . . . . . . . . . 53
CHANNEL-GLASS
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54
. . . . . . . . . . . . . . . . . . . . . . . . . 54
LATCH
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 55
. . . . . . . . . . . . . . . . . . . . . . . . . 55
DOOR
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 56
. . . . . . . . . . . . . . . . . . . . . . . . . 56
. . . . . . . . . . . . . . . . . . . . . . . . 56
HINGE
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60
. . . . . . . . . . . . . . . . . . . . . . . . . 62
STRIKER
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64
. . . . . . . . . . . . . . . . . . . . . . . . . 64
. . . . . . . . . . . . . . . . . . . . . . . . 65
PANEL-TRIM
REMOVAL
1. Remove the screws (3 & 5).
CAUTION: Trim panel is attached to the door using
hooks molded into the panel. Do not pull the trim
panel straight off or damage to the panel and/or
power switch assembly may occur.
2. Lift the trim panel up off the lock rod (2) and
attachment hooks and separate the panel from the
door slightly.
3. Disconnect the electrical connectors (6).
4. Disconnect the inside handle actuator rod (1).
23 - 44
DOORS - REAR
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст