Dodge Durango (HB). Manual — part 1431
WEATHERSTRIP-FRONT DOOR BELT OUTER
REMOVAL
1. Insert special tool #9093 (2) between the outer belt
molding (1) and glass at the rear.
2. Push down on outer belt molding (1) and rotate
upper part of tool (2) outward from vehicle then lift
up on molding (1) to disengage from locking tabs
(3) working from back to front.
NOTE: Typical outer belt molding design shown.
3. Slide molding out from under the side view mirror
and remove.
INSTALLATION
1. Position the outer belt molding onto the door and position forward under the side view mirror. Seat the molding
fully.
WEATHERSTRIP-REAR DOOR GLASS RUN
REMOVAL
1. Remove the glass run channels. (Refer to 23 - BODY/DOORS - REAR/GLASS RUN CHANNEL - REMOVAL)
2. Separate the quarter glass from the weatherstrip.
INSTALLATION
1. Position the quarter glass into the weatherstrip and rear run channel.
2. Install the run channels. (Refer to 23 - BODY/DOORS - REAR/GLASS RUN CHANNEL - INSTALLATION)
WEATHERSTRIP-REAR DOOR BELT INNER
REMOVAL
1. Remove trim panel. (Refer to 23 - BODY/DOORS - REAR/TRIM PANEL - REMOVAL)
2. Pull weatherstrip from inner door panel.
INSTALLATION
1. Position weatherstrip on inner door panel.
2. Press into place.
3. Install trim panel. (Refer to 23 - BODY/DOORS - REAR/TRIM PANEL - INSTALLATION)
HB
WEATHERSTRIP/SEALS
23 - 237
WEATHERSTRIP-REAR DOOR BELT OUTER
REMOVAL
1. Insert special tool #9093 (2) between the outer belt
molding (1) and glass at the rear.
2. Push down on outer belt molding (1) and rotate
upper part of tool (2) outward from vehicle then lift
up on molding (1) to disengage from locking tabs
(3) working from back to front.
NOTE: Typical outer belt molding design shown.
3. Slide molding out from under the side view mirror
and remove.
INSTALLATION
1. Position the outer belt molding onto the door and seat the molding fully starting at the back of the door.
23 - 238
WEATHERSTRIP/SEALS
HB
BODY STRUCTURE
TABLE OF CONTENTS
page
page
GAP AND FLUSH
. . . . . . . . . . . . . . . . . . . . . 240
OPENING DIMENSIONS
. . . . . . . . . . . . . . . 242
SEALER LOCATIONS
STRUCTURAL ADHESIVE LOCATIONS
WELD LOCATIONS
. . . . . . . . . . . . . . . . . . . 264
HB
BODY STRUCTURE
23 - 239
GAP AND FLUSH
SPECIFICATIONS
GAP AND FLUSH
NOTE: ALL DIMENSIONS ARE IN MILLIMETERS.
GAP AND FLUSH
23 - 240
BODY STRUCTURE
HB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст